Why would odometer and speedometer not work and transmission not shift right on a 1996 Chevrolet?
You need to replace the speed sensor on the rear of the transmission.
Under the hood you will see a red cap(has a + symbol), remove the cap and that is the positive hook location to jump the car. The negative is a post that looks like a large nut on the drivers side fender/strut mount area.
What is the gross weight of 1994 Chevrolet pickup?
This information is listed on a placard on the drivers door post.
What is the value of a Chevrolet c10 silverado?
That would depend on a lot of things. Year milage, engine size and over all condition. hard question to answer.
What is the gross weight of a 1971 Chevy Flatbed?
Depends on the model. GM marketed Class 1 through Class 8 trucks during that year.
How much does a mechanic charge to install power booster on a 1978 Chevy sub?
Maybe a half hour- it's a pretty easy job, you don't even have to crack a brake line. Just unbolt old one from firewall, unbolt master cylinder, remove vac hose, unhook brake pedal arm from back (usually just a cotter pin) pull master slightly forward to clear piston and lift up. Put piston in new one and pop it in.
Does a 93 Chevrolet geo have a interference engine?
Yes valves will bend if timing belt goes out while driven.
How much can you bore a 454 Chevy Engine?
It depends on the block, check with a reputable shop. A good estimate is .030 (Or 30 thousandths of an inch, in case I got the decimal wrong.)
How much does it cost to pull a transmission in a 1997 Chevy z71?
$250.00 to pull it and to put it back in if it's not a 4x4
Where is the oil filter located on the 2012 Chevrolet Equinox 2.4 l engine?
This cartridge type oil filter housing is located just behind the dipstick. See sources and related links (below) to see the Equinox forum with a pictorial oil and filter change.
How do lock out hubs work on a Chevy 4 wheel drive?
Lock out hubs release a tensioned spring that holds a splined gear over the outter end of the front drive axle. These cogs are splined to the axle on their inside,and geared to the hubs on their outside perimeter , making the connection between the two when locked in. These are located on each outter axle end ,in the hubs, at the center of the front wheels. When unlocked the front axles and front driveshaft are no longer forced to turn with the tire.
Would a 454 big block fit into a 1951 Chevy 3100?
A big block will fit into a 1951 chev truck. But with quite a bit of mods. Motor mounts will have to be fabricated or purchased, the cooling system will have to be upgraded, but the biggest challenge is the steering gearbox. It will need to move about 2 inches to the left in order to clear the engine and headers. There is a ton of work that would go into this swap. But it can and has been done before.
What did a 1954 Chevy belair 2 door cost new in 1957?
You could not buy a 1954 Chevrolet brand new in 1957. The were only sold new in late 1953 and 1954.
How do you adjust a hydro clutch on a 1997 Chevy 1 ton?
YOU CAN"T, There is NO adjustment, Time to replace the clutch
Will the 2014 Chevrolet Spark come with a sunroof?
According to the Chevy website no, there is no sunroof option.
How do you check your cmp sensor 2005 Chevy uplander?
If you suspect a failing sensor you probably see it is acting up only at certain times. CMP usually under high heat stress to start.
It will either fail or not and the scanner operator will see it.