What fuse controls wipers on transit connect?
I found it was a Yellow 20 Amp fuse (Fuse 56) on the Fuse board.
This can be found by opening the glove box, and squeezing inwards the sides, this then drops down to reveal the fuse board.
NB this was for my Transit Connect 2003.
What is the light on the dash panel that looks like an up arrow on a 2007 ford focus?
Shift light, maybe? If it comes on around at a certain RPM every time, that'd be my guess.
What does yellow warning symbol on BMW 318i means?
The yellow warning symbol is your traction control. It will come on temporarily if you have poor traction, or if you disable traction control by pressing the DSC button, it will stay lit until you turn traction control back on, or you turn the car off.
It sounds like there could be an issue with the alternator or the electrical system in your car. The drop in idle speed and juddering indicate a potential problem with the engine. The flickering interior lights and headlights suggest an issue with the alternator not properly charging the battery. It's best to have a mechanic inspect and diagnose the specific cause to address the problem correctly.
Why would the battrey light come on in a 1984 BMW 318i?
Alternator may not be charging battery sufficiently- check with a voltmeter A fully charged battery should read approx. 12.8 volts without engine running With engine running should read approx. 13.8-14.2 volts
You repaired a bearing in a 2003 jeep rubicon now the locker light flashes?
the sensor in the side of the differential that has the electrical plug on it that's what works the locker light on the dash. when you lock it in that sensor is pulled over by the ring on the side of the locker and when that ring is fully pushed over it changes the light from flashing, to on solid. but be careful if you take that sensor out you can't put it back in without pulling the gears or when you put it back it in it will stay locked all the time i found out the hard way.
What caused emissions code P0302 on 01 mercury mystique?
misfiring on cylinder #2 ,usually you can fix with a new set of spark plug wires,it's important the use of a dielectric tune up grease,coat inside of spark plug boot with a layer of dielectric grease before snap boot onto plug,making sure fit is tight
The light you are describing is the "Low Coolant Level" warning light. It indicates that the coolant level in your car's radiator is low and needs to be topped up. This is important for maintaining proper engine temperature and preventing overheating.
What causes lights to blink in a house?
Lights may blink in a house due to a loose or faulty electrical connection, a power surge, or a problem with the light switch or fixture. It is important to investigate the issue promptly to identify and address the root cause to prevent any potential safety hazards.
a check engine light that flashes while driving has nothing to do with the speed sensor or alternator a flashing engine light shows that there is problem that is causing catylitic conver damage for instance if you had a bad spark plug or spark plug wire that was causing a missfire then the light will flash there is no other reason for the light to flash
The symptoms you described could indicate misfiring in the engine cylinders. This could be caused by issues such as faulty spark plugs, a failing ignition coil, or a vacuum leak. It is recommended to have the vehicle diagnosed by a mechanic to determine the exact cause of the problem and address it accordingly. Driving with a flashing check engine light can potentially cause damage to the catalytic converter.
What does the sensor light on the dash panel of a 1995 Isuzu Rodeo 4x4 5 speed mean?
The sensor light on the dash panel of a 1995 Isuzu Rodeo 4x4 5 speed could indicate a variety of issues depending on the specific symbol or warning displayed. Consult the vehicle's manual for a detailed explanation of the warning light or have a mechanic diagnose the problem to determine the exact cause.
What is most likely the cause of a small evap system leak on a 1997 Mitsubishi Eclipse RS?
it happened to my Honda Accord yesterday also. Friend of mine used scanner to detect that problem and found out that the part name "Purge system solenoid valve" was broken. I hope this will give you a hint for your car. Thia problem can also be caused by an improperly installed air filter housing. The housing may not be sealed properly on its gaskets or the holding clips may not be set. It is an easy item to check! You may want to check your charcoal canister also...I had the same problem just two month's ago and that was the problem...I have a 99 Eclipse RS Spyder.... it is your roll over valve on the fuel tank i have a 97 rs too it had the same problem I would start with making sure you have a good seal on your gas cap as well (three clicks whenever it is removed and put back on). This is one of the most common causes of this code. Also, check all your vaccum lines for cracks from the gas tank to the evap system. Another cause, as mentioned above, is the purge solenoid sensor.
How do you know if a egr valve is bad?
Depending on the vehicle the check engine light would illuminate.
Service engine light reset C320 Mercedes?
Go to the nearest MBZ dealer and let them diagnose your vehicle before it's too late.
How do you reset the engine light on a 2004 suburban?
To clear the change engine oil light, press the gas station symbol on the steering wheel until the engine oil % appears on the dash. Next press and hold the arrow on the steering wheel. Engine oil life should now read 100%.
How do you reset check engine light on 1990 Volvo 240?
1. Purchase an OBD II code reader machine from an auto parts store.
2. Or the easier, cheaper way: take your vehicle to Aamco Transmissions or Midas shop and they will check it for free!
If the Volvo is 1995 or newer, they can pull the codes very easily.
If it's 1994 or older, they can pull the codes but it takes more labor.
Whichever shop you go to may charge you if your Volvo is 1994 or older. But you can always try to negotiate the price down and see if they'll go for it.
The Aamco I took my '94 to wanted $98. I said forget it, but since they took so long with my car they through in the test free.
How do you reset the service light on a 2000 reg Megan?
In order to reset the service light on a 2000 reg Megan you\'ll need to start by turning the ignition switch to the "On" position without starting the engine. Once the service light appears on the dashboard you can reset it by following these steps:
After following these steps the service light should reset and no longer appear on the dashboard.
What are 2004 intrepid check engine codes?
Courtesy of "Skidsmadawg96"
Click here for details on how to get the codes if the following instructions don't work!
(1) Cycle the ignition key On - Off - On - Off - On within 5 seconds.
(2) The Odometer will show the P-code.
(3) If no DTC's are present, the cluster will display one of two texts: "P1684" and "done" or only "done." P1684 indicates that the memory has been cleared within the last 50 ignition cycles and does not indicate a problem. Done indicates that NO DTCs are present.
Ho2S = heated oxyen sensor, TP = throttle position, MAF = mass airflow, MAP = manifold absolute pressure, TC=turbocharger.
Some codes might not be used by Chrysler, or might only be used by some later Chrysler models (e.g. Charger). These will be italicized.
If the check engine light is blinking on your 2005 Dodge Stratus, you most likely have a sensor that is damaged or requires replacement. You can check this by accessing the diagnostic computer at the dealership.
2005 dodge stratus check engine light?
If the check engine light is blinking on your 2005 Dodge Stratus, you most likely have a sensor that is damaged or requires replacement. You can check this by accessing the diagnostic computer at the dealership.
How do you reset the check engine light for a jeep grand cherokee?
Disconnect the positive cable on the battery and reconnect it that should reset it. If there is a true problem it will come back on. or go to an advance or autozone and they will erase the code for you free.
How can i read the check suspension codes on my 93 Lincoln mark 8?
I think the check suspension plug is under the hood on the pass. side and you would need a OBD1 scanner to check it. It's usually gray in color and says air suspension on it.
Dodge Stratus Check Engine Light?
If the check engine light is blinking on your 2005 Dodge Stratus, you most likely have a sensor that is damaged or requires replacement. You can check this by accessing the diagnostic computer at the dealership.