0
Chrysler Sebring
The Chrysler Sebring is a range of middle-sized cars manufactured by American carmaker Chrysler between 1995 and 2010. It is one of the few practically priced automobiles available in sedan and convertible body styles.
2,284 Questions
Have you heard about the front wheels falling off a 99 Chrysler sebring con?
Both of the front wheels on my 99 Sebring have fallen off in the last year. Caused by failed lower ball joints.
Where is the fuel pump located on a 2004 Chrysler Sebring?
The fuel pump on a Chrysler Sebring is inside the fuel tank.
How do you make the negative battery cable on a 1999 Chrysler Sebring longer?
Replace it with a longer cable. That is the safest and best way. You could splice another cable on to the original but I would not advise it.
How long will a 1997 Chrysler sebring's engine last?
I have a 1997 Sebring Convertible. Engine is currently at 152,000 miles and still going strong.
Where are the freeze plugs on a 1998 Chrysler Sebring 2.5 motor?
They are on the front, back, and transmission sides of the engine.
What causes codes P0442 P0455 on a 2002 Chrysler sebring?
Both of these codes indicate a leak in the evaporative emissions control system. The most common cause of this code is a bad fuel gas cap.
Where is the fuse box for Chrysler sebring brake lights.?
Most people just check the in cab fuse box. Check the one under the hood, and to find out which one it may be, look up Fuse in the glossary of your owners manual and it will help direct you.
How do you turn back the odometer on a Chrysler sebring?
You can't. The mileage is stored by the on board computers.
Does a 2003 Chrysler sebring have a timing belt?
The 2.7L has a chain. All other engines have a timing belt.
If it started flashing after the water pump, it is possible that the timing belt/chain is installed improperly.
Where is the thermostat on a 2000 Chrysler Sebring convertible jxi?
On the 2.5L it is under the housing where the lower radiator hose attaches to the engine.
Where is the starter on a 2.7 Chrysler Sebring convertible?
It is on the radiator side of the engine, behind the motor mount bracket.
How do you turn off emergency flashers on Chrysler Sebring car?
Push the flasher button. It will have a triangle symbol on it.
Push the flasher button. It will have a triangle symbol on it.
Where is the reset button for fuel pump on a 2000 Chrysler Sebring?
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
How do you reset the check engine light on a 2008 Chrysler Sebring?
The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light is reset with a scan tool after repairing the cause of the fault.
What is the cost of labor to repair a head gasket?
They only Head Gasket I had to replace was on a Chevy Malibu 1999. Cost me about $1400
Why does the alarm not shut off on a 1996 Chrysler Sebring LXi?
I have a convertible and had this problem. Fixed when i put the key in the driver side door and locked and unlocked it. It reset the alarm. Hope this helps.
How do you reset oil warning light on a 2008 Chrysler Sebring?
To reset the oil warning light on a 2008 Chrysler Sebring, turn on the ignition without starting the engine. Slowly push the accelerator down three times. Next, turn the ignition to the lock position and the warning light should be gone.
How do you replace the headlight bulb on a 2005 Chrysler Sebring?
Raise the hood and on either side there are two 7mm bolt heads, on top of the metal frame, pointing downward. Remove these two bolts (one long and one short) and this will release the headlight unit. Pull it out far enough to unplug the bulb and turn the large plastic retainer nut and remove the bulb. The headlight unit may be caught on the plastic cowling and you may have to depress the plastic cowling in order to slide it out. You also may have to release the two plastic retainers that hold the top of the plastic cowling to the metal frame. If you do, pop up the centers and then remove the retainer. Cowling can then be moved enough to get the headlight unit out.
