What are common problems for Chrysler pt cruisers?
My PT Cruiser runs fine for awhile, then acts like it is out of fuel. Then in a few seconds it is back to running fine.
Does the 2000 pacifica Chrysler 3.5 engine have a timing chain or timing belt?
It has a timing belt.
It has a timing belt.
What ignition wires does Chrysler recommend for 2005 pt cruiser?
Chrysler recommends the plug wires they sell in their parts department.
Chrysler recommends the plug wires they sell in their parts department.
Where can you buy red 5 year hoat type antifreeze?
Dodge, Jeep, Chrysler dealer. Also look for any aftermarket type that says it is compatible with Chrysler. Zerex G05 is compatible.
Dodge, Jeep, Chrysler dealer. Also look for any aftermarket type that says it is compatible with Chrysler. Zerex G05 is compatible.
How is the code cleared on a Chrysler crossfire after an oil change?
Disconnect the battery for at least several minutes. That should clear all codes in memory
What does p0731 mean on a Chrysler 300?
Incorrect gear ratio in first gear.
Incorrect gear ratio in first gear.
Where is the fuel pump located on a 1990 Chrysler convertible?
It is inside the fuel tank.
It is inside the fuel tank.
Is Chrysler and dodge the same?
Chrysler is the name of the corporation and the nameplate on an automobile the corporation makes. Dodge is the nameplate on another car made by the Chrysler Corporation.
Where is the shift solenoid for a 1999 Chrysler 300?
The solenoid are on the valve body inside the transmission.
The solenoid are on the valve body inside the transmission.
How do you change the ignition coil on a chrysler Sebring with the 2.5?
You have to replace the distributor assembly.
You have to replace the distributor assembly.
Where is the ac drain for Chrysler 300 2006 2.7?
It is over top of the transmission, behind the heat shield.
It is over top of the transmission, behind the heat shield.
What does a code P0300 mean on a Chrysler 300m?
P0300 Diagnostic Code - Random Misfire
Symptoms.
Engine may stumble or miss
Engine may be hard to start
you may notice no issues
Cause
Failing spark plugs or spark plug wires
Bad coil or coil pack
Failing oxygen sensor(s)
Bad fuel injector or more than one
Stuck exhaust valve
Bad catalytic converter
EGR valve or valve passage clogging
Bad camshaft position sensor
Bad PCM or ECM
The Fix
Best first action is a tune up, new plugs, wires, inspect all hoses and wire connections then reset the code. If it returns you will need to narrow it down to a system, coils and coil packs should be tested, catalytic converters for function ( do you smell rotten eggs?). A misfire that jumps cylinders could indicate a lean condition, do you have any other codes along with the 300? this will help clue you in to the source, check valve function to make sure they are opening and closing fully.
This is probably pone of the most difficult codes to troubleshoot, so start with the basics and work your way into the more expensive options, in many cases a good old tune up solves the problem, back it up with a fuel system cleaning and see where you stand.
How do you pull out the kill switch in a Chrysler 2004 Sebring sedan?
Chrysler does not have a kill switch
Chrysler does not have a kill switch
Can you add a 8th seat to a 2010 chrysler minivan?
Not without major modifications. You would have to remove the center row bucket seats and install a three seat bench in its place. Since they do not offer that configuration, you would have to make all mounting brackets.
Not without major modifications. You would have to remove the center row bucket seats and install a three seat bench in its place. Since they do not offer that configuration, you would have to make all mounting brackets.
Is the 2004 Chrysler 2.4L engine an interference or non interference engine?
It is an interference engine.
It is an interference engine.
Did Chrysler make outboard motors into the 1990's?
No, Chrysler sold it boat motor companies in 1984
No, Chrysler sold it boat motor companies in 1984
How do you program key fob for Chrysler 300 without old fob?
The dealers scan tool is required.
The dealers scan tool is required.
What does diagnostic code p1776 mean on a 2002 chrysler 300m?
Solenoid switch valve latched in the low/reverse position. On a 300M it is usually a failed transmission solenoid pack.
Solenoid switch valve latched in the low/reverse position. On a 300M it is usually a failed transmission solenoid pack.
Is the top of the Chrysler Building covered in bronze?
no it is covered in coper.
The top 88 metres are covered with stainless steel.
How much atf 4 does it take to drain and refill?
Not enough info.
A front wheel drive holds about 9 quarts empty.
A rear wheel drive gas engine holds 12 quarts
A diesel holds 16 quarts.
Not enough info.
A front wheel drive holds about 9 quarts empty.
A rear wheel drive gas engine holds 12 quarts
A diesel holds 16 quarts.