Where might one go to purchase Cisco Linksys?
Linksys VOIP adapters can be bought from a variety of stores, including online stores. Some places where this item can easily be found include Amazon and eBay.
What is a function of the console port on a router?
To connect to a terminal for initial configuration
What kind of course takes a Cisco CCNA exam?
The Cisco.com website lists all the classes and exams you need to take to get a CCNA certification. The beginning class begins with Interconnecting Cisco Networking Devices. If you have no previous networking experience, a CCNA certification will help you get in the door, but will do little else. Most industry professionals prefer experience over a CCNA.
Which connection provides a secure CLI session with encryption to a Cisco switch?
To provide a secure CLI session with encryption to a Cisco switch an SSH or Secure Shell connection will be required as this uses a cryptographic network protocol that provides secure data communication.
A Cisco switch is a piece of network hardware which has been manufactured by Cisco Systems. Usually Cisco switches are 'managed' switches, which means they can be accessed via the network and configured to perform advanced features such as VLANs, DHCP and routing. They are typically more expensive than a standard network switch and can cost up to tens of thousands of dollars.
VLAN is Virtual Local area network and it is a group of hosts with a common set of requirements that communicate as if they were attached to the same broadcast domain, regardless of their physical location. VLANs are configured through software rather than hardware, which makes them extremely flexible.
Wikipedia: Cisco Systems, Inc. (NASDAQ: CSCO, SEHK: 4333) is a multinational corporation headquartered in San Jose, California, that designs and sells consumer electronics, networking, voice, and communications technology and services. Cisco has more than 70,000 employees and annual revenue of US$ 40.0 billion as of 2010. The stock was added to the Dow Jones Industrial Average on June 8, 2009, and is also included in the S&P 500 Index, the Russell 1000 Index, NASDAQ 100 Index and the Russell 1000 Growth Stock Index.
Which of the following commands sets the secret password to Cisco?
In the global configuration mode, type enable secret <password of preference>
See below example:
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#enable secret password
Router(config)#exit
Router#
Is the computer a data terminal equipment?
A Data Terminal Equipment (DTE) is a communication device that is the source or destination of signals on a network, typically a terminal or a computer. It communicaties with the data circuit-terminating equipment and can perform all the required functions necessary to permit users to communicate.
The router discards the packet.
The router forwards the packet out the interface indicated by the default route entry.
What is port security in cisco?
port security is a CLI command used to restrict access to a network from a cisco switch by allowing access only to the hosts whose MAC addresses are defined in the switch. except the allowed hosts remaining hosts will be blocked based on the violation mode chosen.
Which encapsulates segment into packets?
TRANSPORT LAYER
The transport layer ensures that messages are delivered error-free, in sequence, and with no losses or duplications. It relieves the higher layer protocols from any concern with the transfer of data between them and their peers.
The size and complexity of a transport protocol depends on the type of service it can get from the network layer. For a reliable network layer with virtual circuit capability, a minimal transport layer is required. If the network layer is unreliable and/or only supports datagrams, the transport protocol should include extensive error detection and recovery.
The transport layer provides:
Typically, the transport layer can accept relatively large messages, but there are strict message size limits imposed by the network (or lower) layer. Consequently, the transport layer must break up the messages into smaller units, or frames, prepending a header to each frame.
The transport layer header information must then include control information, such as message start and message end flags, to enable the transport layer on the other end to recognize message boundaries. In addition, if the lower layers do not maintain sequence, the transport header must contain sequence information to enable the transport layer on the receiving end to get the pieces back together in the right order before handing the received message up to the layer above.
Network Layer
What is the mission statement of CISCO?
Cisco ... enables people to make powerful connections - whether in business, education, philanthropy, or creativity. Cisco hardware, software, and service offerings are used to create the Internet solutions that make networks possible-providing easy access to information anywhere, at any time."
Where can you buy a VPN router?
A BEFSX41 router can be purchased at Best Buy, Radio Shack, Walmart, Target and any other store that carries electronic and computer equipment. Used routers can be found on Amazon.
Where might one find information about Cisco Systems Inc?
The best place to go to read on Cisco Systems Inc in to go to the Cisco website. That would give the most accurate information. But one could also go to Wikipedia. Althought it has good information, some of it may not be entirely accurate.
Which cable is use for similar device?
A crossover cable is necessary for two similar devices to talk to each other without the use of an intervening network connectivity device because the transmit and receive signals must be crossed between the two devices.
This is what a hub or switch would normally do. If a normal, straight through cable were to be used it would connect the transmit signal to the transmit signal on the other device, which is equivalent to two people talking to each other at the same time with no way to listen to what they are saying.
With a crossover cable the transmit signal on one end is connected to the receive signal on the other end so the two devices can talk and listen to each other.
What are the technical specifications of the Cisco 3825 Integrated Services Router?
The Cisco 3825 Integrated Services Router consist of wired connectivity, three types of remote management protocol, and preinstalled firewall protection. The product is no longer supported so exercise caution when purchasing it.
What is a computer system's organization?
Storing and managing information is an important task of the computer system. Since the information plays an important role in a computer system, its logical and physical characteristics are also a matter of interest as these effect the efficiency of programs using it.
Computer system are comprised of input devices, output devices, processing devices, and storage devices. Input devices would include a keyboard, mouse, microphone, sound card (if it uses a microphone), and read-only storage devices. Output devices would include the video card, monitor, sound card, and speakers. Processing devices would include the CPU, and the FPU. The video and sound cards could be considered processing devices, since they also process images, video, and sound. Storage devices would include ROM, RAM, memory sticks, memory cards, the hard drive, and CD/DVD burners.
Which events will cause the VTP revision number on a VTP server to change?
Adding, modifying, or removing a VLAN from the VTP server will cause the revision number to change. Another possible way is if a Client gets a higher revision number than the server. If this happens the server will take take the revision number and the VLAN information from the client and advertise the information to everyone in the VTP domain.
What services are offered by the Cisco Academy?
The Cisco Networking Academy provides training on construction and maintenance of networks. This includes courses for specific certifications, such as Cisco CCNA and Cisco CCNP. The training is done through various partner organizations that provide the necessary space, instructors, etc. More information can be found on the Cisco website.
Cisco routing can work through a number of ways. Some of these ways include the usage of a network switch. Also, the usage of a multicast NAT connection may be necessary to route the signals from Cisco.