0
Commercial Vehicles
Commercial vehicles can include fleet vehicles, company cars or other vehicles used for business.
500 Questions
How do you changeair bag on peterbilt 379 sleeper?
Asked by Wiki User
It's really quite easy, although you will need a means of either lifting or jacking up the chassis when you install the new one.
Disconnect the air lines going to the air bag. Unbolt the air bag from the top and bottom... the top is usually two small bolts, and it'll be a larger bolt on the bottom. Off the top of my head, I don't remember exactly what size they are.
The old air bag will pull right out at this point.
Clean off the air fitting threads with a wire brush.
Install the new air bag... before reattaching the air fittings, make sure you put some thread tape or liquid thread sealer on them. To install the new air bag, you'll have to either jack up the chassis or lift it up... at work, I use an overhead crane for this.
Reinstall the bolts. The smaller top bolts should be torqued to 20 - 25 ft./lbs. and the larger bolt on the bottom should be torqued to around 50 ft./lbs.
How far can you go with 1 liter of diesel van?
Asked by Wiki User
about4.2km
Updated answer,
4.2km, and how far can you go with a carbon fiber tank full of compressed air, this is what MDI has been trying to find the answer to, and to a point they have found the answer. Clean cars google MDI compressed air cars, and see what they are trying to achieve.
A car to clean the air of cities, yes it may be inefficient, but would you drive an inefficient car if it did not pollute the air you breath.
Petrol cars were inefficient when they were first developed, have a look "Get Behind the Compressed air car and maybe you'll breath"
How do you replace pinion seal?
Asked by Wiki User
Some of those setups have a crush sleeve that must be replaced along with that seal. It also requires specific torque specs To replace seal, remove the drive shaft, remove the pinion nut and crush sleeve if required, remove seal, install new seal and crush sleeve install pinion nut and torque to specs
What is the difference between Upfitting and Refitting Fleet Vehicles?
Asked by Wiki User
If you went to the dealer and bought a "cab chassis"--just the frame rails sticking out behind the cab--then took it to Dixie Upfitting and had it turned into a refrigerated box van, it would have been upfitted. If you went to the same dealer, bought a used dump truck, then took that truck to Dixie Upfitting and had it turned into a refrigerated box truck, it would have been refitted.
Will following too closely go on your record?
Asked by Wiki User
Yes it does and it is one of the worst tickets you can have on your record if you have a CDL and drive for a living.
ARE vehicles required to have a federal motor carrier annual inspection?
Asked by Wiki User
All commercial motor vehicles and trailer need to be inspected either by an approved state program or the federal annual inspection 49CFR section 396.17
Why would brakes lock up on 2001 Triton ute?
Asked by Wiki User
Front caliper piston seals are gone can get kit for 35 bucks
What type of gear oil do trucks use today?
Asked by Kflw2121
This is necessary since the devices needing this heavy oil do not have pumps for ... the GL1 class of gear oils does not contain any EP additives.
How do you turn off ABS Light on 2001International 4700?
Asked by Wiki User
The best way to do it is to repair the problem. If there isn't actually a problem with your ABS system, then it's probably a faulty sensor.
How much does shipping a vehicle cost?
Asked by Wiki User
Depends on several condition such as vehicle type, destination and distance, route, time of the year, and any other additional cost such as shipping insurance and import taxes if you are shipping it to another country. To get better estimation simply get quoted from vehicle shipping companies by entry your details. Just search for vehicle shipping companies on internet or visit the link on the sources box below.
Moter cycle 25 kw what is this in cc?
Asked by Wiki User
Cant tell for sure. A good engine will have a small cc for its KW, while a crap one will require more cc. CC relates to the size of the engine, while kw refers to the power. Id say a 125 at a guess
What action would be taken in case of significant environmental threat in the work site?
Asked by Wiki User
report to EPA
How often is a DOT inspection requried for a class 8 truck?
Asked by Wiki User
The FHWA inspection is required annually, and it's not limited to just Class 8 trucks.
