Electronics Engineering

fully charged.

may be

Actually, measuring winding resistance with a multimeter is an iffy situation at best. This is because the multimeter will not tell you if one of the turns is shorted, causing Q to drastically suffer, it will really only tell you if the winding is open, or if it is shorted to something it should not be shorted to, such as the frame.

This is especially true for larger windings, in larger transformers and motors, because their DC resistance is so close to zero that you might not be able to tell if they are shorted or normal.

Using a multimeter is a good start, to make sure that basics are covered, and it might tell you if the winding is dead shorted, but you need to know for sure what the expected DC resistance is, and you need to know that you multimeter is very good in the low Ohms scale.

b for silicon

Output Power divided by Power Factor.

Two eight-ohm resistors in series would have a total resistance of 16 ohms.

Two eight-ohm resistors in parallel would have a total resistance of four ohms.

The simplest way is the Ideal Model representation of a diode.

Forward: V=0(short circuit),r'd=0,I=use Ohm's law.

Reverse: V=Vbias(Open Circuit),I=0,r'R=0.

Ideal model means it is acting as a switch.

3 Ampere

Every multivibrators have two states:quasi stable and stable state.

quasi stable state are triggered state, when a trigger pulse is given the vibrator reaches this state.

For example,

Astable multivibrators have no triggers so,two stable states.

Monostable multivibrators have one trigger so,one stable and one quasi stable which is invoked by the trigger.Same for the Bistable in which two sates are invoked by two triggers.

Direct band semconductors are mostly for LEDs. Indirect band semiconductors like Si and Ge are conventional diodes.

No world is a stage, and you cannot detect a helicopter unless you have the radar station (radar alone is not sufficient)

Most likely yes depending on your inverter and how long you run it. I have done it once before. I ran a sub woofer and a PA horn in my dad's work van for fun. Ran it for about a half hour.

It was a 1000 watt inverter on a 700cca battery. The amplifier was bridged to 150 watts RMS.

If you run more power you might need a bigger inverter. Out inverter also has circuitry that filters out noise.

L= un2 A/l

it means that it's star connected on the motor part

Yes of course.. u just need some connecting wires to connect them in parallel

An inductor resists a change in current. It does this by converting the current into a magnetic field. If the current then changes, the collapsing or increasing magnetic field will buck the attempted change through electromagnetic energy conversion.

It used loads for it.

The type of diode used to convert alternating current in to direct current is the power diode.

The smoke spreads very far.

In order to convert fm to pm, the modulation index must be set to be independent instead of having a variation. Then the receivers must be properly synchronized.

bjbl,

Open, closed, parrallel, and series.

ANALYSER can rotate

There are many applications of this acceptor circuit. You can learn more about them with some electrical training programs.

The presence of mobile and bound charges on either sides of the pn junction causes the depletion layer.

A pn junction is formed when a semiconductor is dopped with a pentavalent impurity on one side and a tri-valent impurity on the other side.on one side electrons will be more in number and on the other side holes will be more in number.At the junction the electrons combine with holes and there will be no charge carriers(i.e. electrons and holes) in that region.That region which is free from charge carriers is called depletion region.