answersLogoWhite

0

Hydraulics

Due to its immense power, hydraulics are used for operating various machinery, vehicles, aircraft, ships and equipment. The data and engineering revolving around hydraulics is so vast, its hard to comprehend.

1,856 Questions

What the uses of hydraulic press?

The idea behind the hydraulic press (machine or bench press) is that a liquid, when displaced, will exert pressure or force equally across the surface it is forced against. Because of this, hydraulic presses are commonly used for automotive and industrial repair shops, where pressing, bending, straightening, and forming is required.

Does hydraulic oil have a shelf life?

Yes, and this is determined by the manufacturer.

Why are liquids good for Hydraulics?

Liquid is needed to use hydraulics. It's what makes hydraulics work.

Where do you check hydraulic fluid on a Massey Ferguson 698?

from back of tractor right side below cab in front of rear axle a small dip stick is located.

How do you add hydraulic fluid to backhoe?

Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.

What is hydraulic efficiency?

Hydraulic efficiency is the rate at which a hydraulic consumes gases and liquids to find different ways to make our lifestyles more efficient.

Ex200-2 hitachi excavator has a hydraulic problem?

hitachi ex200-2gerakannya lambat, kalau jalan tersendat-sendat dan mesin panas

Why don't we use water in hydraulic systems instead of hydraulic oil?

Water can cause steel components to rust. Oil is much less corrosive.

Why hydraulic oil is used not water in hydraulic system?

because water evaporates

hydraulic oil is non corrosive and an excellent lubricant.

What is a example of a hydraulic skeleton?

jellyfish

worms

starfish

sea urchins

coral

sea anemones

What are the advantages of hydraulic brake compared to wires and pulleys?

Wires stretch and sag. Hydraulic fluids transfer force with far smaller losses.

Why does my 743 bobcat have not hydraulic pressure?

most likely your charge pump or main pumps are not working or being driving. From as simple as the belt not spinning them, to something after pulley, that is sheared or broken

How do you repair a 1950 takara belmont barber chair arm is stuck and wont go forward to lift or go down?

I have 4 takara chairs around the 50's vintage. 3 of them dont go up or down. I dismantled 3 of them and the hydraulic cylinder has seized. There was plenty of oil in them but the piston is stuck in the bottom of the cylinder. The cylinder is sealed at the end with a crimped end cap so the cant be repaired. I am going to drill a hole in the end cap and belt the piston out and see what happens. I have found out you cant buy parts for them!