Industrial Engineering

Metric thread pitch is measured directly from crest to crest of the thread form.

For example the distance from crest to crest of a M8 x 1.25 MM thread would be 1.25 MM.

Another way to measure it would be linear travel per rotation, in which case a M8 x 1.25 MM thread would travel 1.25 MM each rotation.

You need a 5.5kw generator to run a 5.5kw motor.

wool has many crimps so it can carry steel and it is elastic

A transformer has two windings, termed the 'primary winding' and the 'secondary winding'. The primary winding is the winding connected to the supply, while the secondary winding is connected to the load.

The secondary voltage of a 'step up' transformer is higher than the primary voltage; the secondary voltage of a 'step down' transformer is lower than the primary voltage.

The simplest way to determine whether a transformer is a step up or step down, is to measure the primary and secondary voltages. If you are simply looking at a transformer, then the transformer's insulated bushings will give you a clue -the higher voltage bushings are much bigger than the lower voltage bushings. If you have access to the inside of the transformer, then the higher voltage windings are thinner and have a greater number of turns than the lower-voltage winding.

An oscilloscope is, essentially, a voltmeter -it measures current by measuring the voltage drop caused by that current across a standard resistance.

Range is the difference of cooling water inlet and cooling water outlet temp

Because the water pressure at the bottom of the dam is much more than the top.

A constraint which is not required or is extra, presence or absence of such a constraint does not effect the solution of problem

Yes

It depends on the ceramic. Most ceramics have fracture toughness between 0.7 AND 1 MPa - m^1/2. Some are lower, and some higher, up to 5 MPa-m^1/2

Industrial Engineering is a extended branch of Mechanical engineering but now stands a separate entity. It involves work study, method study, time study, optimization techniques, value engineering. It focuses on improving the way a work or job is done. If one wants to improve an activity, optimize an activity either by man or machine, Industrial Engineering tools offer solution.

plastic

40

women

yes it is possible by turning and milling..................

1. to protect the plant

2. to support the plant

3. To respons to changes in the plant

4. to monitor process parameters

18000 volts clearance

Practically it won't, be the air will get compressed, and then the hoist will not work. Read Pascal's principle to check if my answer if correct.

While the Bible states that a worker is due his wages, there isn't a mention of railroads or infrastructure that precipitated the Industrial Revolution.

Daily life you use reciprocating pumps buy using your water faucet, pumping gas or simply using a suringe for medicine.

Yes.

In fact, titanium was the strongest material on earth until just recently.

American society of mechanical engineers has a classification of pressure vessels. Certain type of the boilers have H stamp according their classification, and this stamp is required by local authorities in order to get boiler approved for installation.

Load rejection occurs when load is suddenly removed from the generator. The most obvious example of this is the breaker connecting the generator to the power grid opens. This results in a full load rejection.

Load pick up means the generator is supplying power to a given load. When a generator comes on line, it will pick up some load that might have been supplied by another generator.

it is useful for analysing the movements in short cycle repetitive jobs.