0
Jeep Commander
Jeep Commanders are a midsize SUV that was produced from 2006-2010.
284 Questions
How remove 2006 Jeep commander speedometer gear?
It does not have a speedometer gear. The speedometer is electronic and gets its signal from the ABS and transmission computers from the wheel speed and transmission speed sensors.
It does not have a speedometer gear. The speedometer is electronic and gets its signal from the ABS and transmission computers from the wheel speed and transmission speed sensors.
Where is brake lamp switch on jeep commander?
Under the dash, alongside the steering column, on a bracket so that the operating rod is depressed by the brake pedal lever.
It is removed by twisting 30 degrees anti-clockwise and pulling towards oneself. To remove from wiring harness, prize out the wiring plug with a flat bladed screwdriver.
How do you reset service light on jeep commander 2006?
You need a code reader which plugs into port under dash. Any shop that has 1 can do for you or you can buy 1 at an auto parts store.
Where is transmission filter on Jeep commander?
The transmission filter or filters are on the bottom of the transmission, inside the transmission pan.
It is the ESP light. That is the anti skid system.
Is there a rear reservoir tank for the rear wiper on a 2006 Jeep Commander?
No. Both washer systems use the under hood reservoir.
What is the name of the actor in the jeep commander commercial?
Steve Lyke is the driver. He has a website: www.stevelyke.com
What is the tow capacity of a 2007 jeep commander?
Depends on the engine and whether it has a towing package
How do you lower the spare tire down on a jeep commander?
Behind lift gate, you will find a tray with the jack and tire changing accesories. In that tray, is a plastic plug the size of a quarter or so. Remove that and you will see the key that lowers the spare. Using one of the segments of the tire wrench, turn that to the left until the spare lowers from the bottom of the vehicle.
With out knowing what trouble codes have set, it is hard to say. Have the system checked for codes.
With out knowing what trouble codes have set, it is hard to say. Have the system checked for codes.
How do you reset the oil change light on your 2008 jeep commander?
Key on engine off, press gas pedal to the floor three times, cycle key off ans on. Light should be reset.
Reset jeep commander check engine light?
After fixing the cause of the code, you reset the code with a scan tool.
What type of transmission fluid is used for a 2006 jeep commander Limited Edition?
Mopar ATF+4
Mopar ATF+4
2007 jeep commander transmission over temp signal on car won't start?
saME THING HAPPENED TO MINE, I FOUND LOOSE WIRE GOING DIRECTLY INTO STARTER, GIVE IT A PUSH AND SNUG ITY UP
How do you change the tail light on an 2007 jeep commander?
2007 Jeep Commander tail light bulb lamp replacement procedure: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Where is the oil filter located on a Jeep Commander 3.7L V6?
Front driver side of the engine.
Front driver side of the engine.
What is the best car battery for a 2006 jeep commander?
Any battery can be a good battery. The Walmart battery is an excellent battery at a good price. Know that Walmart does not manufacture batteries and it is made by one of the 4 manufactures in the U.S. The best battery would be an Optima but they are pricey.
