What type of oil filter does 2006 jeep commander take?
You will have to travel to an auto parts store in order to buy the filter. Once you get there they can tell you the exact size filter for your jeep.
Is it legal to drive on minnesotas roads in a jeep commander with demon eye head lights?
Unless it was installed stock in the Factory, No.
Will a 265 - 60 - 17 size tire fit a 2006 jeep commander without rubbing?
i have right now 265 - 65 - 17 on it without any mod
Where is oil filter location on 2007 jeep commander?
3.7L and 4.7L it is on the front driver side of the engine.
5.7L, it is on the front passenger side of the engine.
What does a jeep commander 2007 spare low pressure mean?
Either a tire has low pressure, or one of the tire sensors is going bad. The dealer has special tools to diagnose.
What is the recommended oil for jeep commander 06 with 16000 miles?
Depends on the motor. The 5.7 HEMI takes 5-20W and only 5-20W or else the check engine light will come on with an error for the wrong type of oil. Check to see what motor you have, then get the specs from jeep's website. You can download an owner's manual from the jeep website for your specific model.
What does it mean when my jeep commander shakes while braking a high or low speeds?
Your brake rotors or drums are warped and need replaced.
Where is the tire sensor located on the 2006 jeep commander?
It is inside the wheel attached to the valve stem.
It is inside the wheel attached to the valve stem.
Where is the iac valve on the jeep commander?
I only know on the 2006 Jeep Commander 3.7L V6 engine that the IAC -- Idle Air Control Valve is toward the back, right side of the throttle when facing the engine and its above what might be the TPS -- Throttle Position Sensor. Just unscrew the black air box that has the 3.7L V6 written on it and you should be able to get a clear view of what your looking for. I am not a professional so please excuse the incorrect wording if there is any.
Where does the transmission fluid go on 2006 jeep commander?
if it's an automatic trans. then you pour it into the the hole for the dip stick using a funnel, if it's a manual trans. with no dip stick then there should be a fill plug similer to the drain plug on the side of the transmission under the vehicle. call dealer to find out trans capacity and check the flued level with trans hot.
What is the front sway bar bushing for a 2006 jeep commander?
Its a 100.00 part that we dealers charge you 500.00 to fix....
How do you remove the seat covers on a jeep commander?
The front seats are each held in by 4 bolts to the floor pan. You may need to adjust the track position to remove them, but it is relatively straightforward. The second row is held in by 8 bolts/nuts. They are all the same size. Some are on a front cross member which should be covered by a plastic shield near the outboard passenger and driver side rear doors. The others can be accessed by folding and tumbling the 40% seat forward. The seat is heavy so get a friend. The outboard strikers are attached to the vehicle so use care in making sure the seats stay tilted up and don't relatch while removing or else you wont be able to pull them out. Also, make sure no one rides in it while it is unbolted as this would be unsafe. Contact the dealership to verify the attachment torques when re-installing. The 3rd row has nuts and bolts which you can access by folding the seat flat. After removing this you can rotate the seat upward and slide it rearward (it rests on two strikers in the front).
Could someone please tell my where the location of the oil drain plug on a 2006 Jeep Commander?
It is located somewhere on the lower part of the oil pan. Crawl under the vehicle and look around. It is there, you are just missing it. There may be a hole in a gravel shield that allows access to the plug.
How do you change the thermostat in a 2007 Jeep Commander?
Locate the thermostat housing. It is the spot behind the fan blade where two hoses connect. Unhook the large radiator hose. Unbolt the bolts holding the hoses in place. Coolant may leak out, so you may want to place a bucket under your Jeep and a bit behind the radiator to catch it. Swing up the manifold and scrape off the old gasket. Pull out the old thermostat. Make sure the thermostat casing and all the surrounding hardware is clean. Spread some RTV on the gasket. Place the new thermostat in the housing, ensuring it is lined up properly. Put the manifold back over it, and bolt it back down. Top off the radiator with 50/50 mix.
How do you remove the dash speakers on a jeep commander?
just remove the grills off the speakers with a flat head screw driver
What size wipers does a jeep commander overland use?
It will vary depending on the year of the Jeep Commander Overland. See sources and related links below to lookup the correct wiper blades by vehicle year, make & model.
Service 4wd system for jeep commander?
The system has detected a malfunction and set a code. You will need to have it checked with a scan tool.
How many quarts does a 2006 jeep commander transmission hold?
6 1/2 if you do not drain the converter