0
Knot Tying & Ropework
A knot is simply a connection in a of rope formed either by passing one free end through a loop and drawing it tight or by entwining or tying together pieces of rope.
297 Questions
If you tie your horse to a post how should you tie the knot?
Horses are not typically tied to a post by their reins - It is not unusual to tie a horse to a hitching ring or rail with a half hitch. This has little resistance and an untrained horse can simply pull away from it.
Knots for joining lines for resque?
a figure eight follow through is the most commonly accepted knot for climbing and rescue.
What is the Larks Head knot not used for?
The question cannot be answered, as there are many things it cannot be used for but it may be the first step in making a knot for things it should be used for.
The Lark's Head knot, referred to as such by the Boy Scouts, is more often called by sailors and others as a Bale Hitch or Cow Hitch. The Lark's Head is usually made in the bight (the middle of a line when neither end is available to tie a knot) and consists of 2 Half Hitches made in 2 directions against each other. The Lark's Head can be made in a second with one hand and is an easy way to secure anything where the loops may be slid over a post or rail. The Lark's Head can be used as the first step in making other knots as well, such as a Slip Knot. Because the Lark's Head can be made in a second using just 2 fingers, it is popular when it can be used.
Consequences of Inward knots on your head?
Every person has dips, dents, and "knots" on the skull. These are inconsequential. They have no negative consequences. However, from time to time, a place might be sore, especially when touched. Doctors will simply tell you, "Well, then don't touch there!"
Which is stronger a long rope or short rope?
Technically it doesn't matter. The length of a rope has no impact upon its breaking point and its strength. How the rope is anchored and any knots used is most important and usually will be responsible for the breaking point.
The Flemish coil is the attractive way to store a line on a boat when it is not in use. This is a flat coil, laid on the deck, with the end of the line in the center and the unused portion of the line wound around this. Depending upon the type of line, it is more difficult to make an attractive Flemish coil that it might appear. These are often found on the bow of sailboats when at dock because of their attractive appearance, but it is not a proper means of storing a line when a boat is underway.
Depending upon the type of knot, it serves many purposes. There are thousands of different knots, and each has a particular best purpose. This ranges from making clothing, or fasteners on clothing, to ornamental and even functional designs, to the type of knot most people think of - to secure something from movement.
What does it mean when you can tie a knot in a cherry stem?
Cherry stems are short and easily snapped. Tying a knot in one without breaking it requires dexterity.
Answer 1
I think you mean "flake" a line which is a way of laying the unused tail of any rope on the deck so that it is out of the way, looks neat, but won't get tangled if you start using the rope again. There are many ways to do this.
I don't know where the above answer was derived from but I am active duty navy and it is called "fake" why i do not know but, faking down a line is laying it up in the same manner as for coiling down, except that it is laid out in long, flat bights, one alongside the other, instead of in round coils. this is straight out of a navy publication. you can google basic seamanship chapter 7 and there will be a whole 16 pages to fill you in.
_________________________________
Answer 2
As often happens with historical nautical terminology, both "fake" and "flake" are different methods of doing the same thing and are often (though technically incorrectly) used interchangeably. A Flemish flake is the coil one often sees on the unused (running) end of dock lines.
This is done generally by people who want to appear 'yachty' and is generally used when both ends of line are secured (bitter), not to neatly stow a running end.
When done properly, it will allow a line to pay out smoothly from the center without tangling (fouling). It was common at one time for unloading merchant boats on a crowded dock because it is compact. It does take a bit longer and must be done in the correct direction lest the line's lay cause it to kink or roll, but with experience it can be done from above with one hand as the line falls to the deck.
"Faking" is using long bights (as mentioned) or overlapping figure-8s to achieve the same thing. One sees this on deck when a measured amount of anchor rode is paid out and runs free as the anchor falls but it unsuited to crowded docks because it tends to foul on the cleats.
What is use square knot joint for electrical?
A square knot joint, often referred to as a reef knot, is primarily used in electrical applications for tying two ropes or wires together, especially when both ends are under tension. It is useful for securing connections in temporary setups, such as outdoor events or installations. However, it is not recommended for critical electrical connections as it can slip under certain conditions. For permanent and secure electrical connections, other methods like soldering or using connectors are preferred.
To knot a du-rag, start by placing the fabric over your head with the longer tails hanging down in front. Cross the tails at the back of your head and bring them back around to the front. Tie them in a simple knot, ensuring it’s snug but not too tight. Finally, you can tuck the ends under or leave them hanging, depending on your preference.
How do you do slydini silk knot trick?
The Slydini Silk Knot trick involves creating the illusion of tying a knot in a silk handkerchief without any visible movement. To perform it, hold a silk in each hand and create a loop with one silk while the other passes through it, maintaining control of the silks. As you pull them tight, subtly manipulate the silks to give the appearance of a knot forming. Practice is essential to ensure smoothness and misdirection, making the trick seamless for your audience.
How do you coil a rope without getting kinks in it?
This depends upon the type of rope, it may be of three types - a neutral lay, right hand lay, and left hand lay. This describes how the rope is built up from its smaller parts. For a neutral lay rope, which is common for many braided ropes, you can coil the rope without any special technique and it will coil properly. Stranded ropes, where you can see the diagonal lines, called contlines, along the rope require a technique or they will kink. As you create the coil lopps, whether on your arm or on a post, you must alternate every other loop with a twist. That is, make one clean loop, and the next loop requires you to put a twist to right or left, depending on the rope lay, as you place the 2nd loop. This is continued until the rope is fully coiled.
How do you make the Isis Knot?
To make the Isis Knot, start with a length of cord or rope and form a loop, leaving a long end. Cross the long end over the loop, then wrap it around the loop and pull it through the space created. Tighten the knot by pulling on both ends, ensuring it's secure. Adjust the knot as needed for your desired size and finish.
Knot tying is an ancient art which originated due to practical purposes.
Grasses and reeds were and still are used to make strings and ropes which then are connected together in an intersection now referred to as a knot, for a variety of practical purposes.
Yes, the definition is 'any knot that is improperly tied, but looks correct'. So the granny knot is a liar's knot if you intended to tie a square knot.
Yes, it is a series of repeated knots. My mom used to 'crochet'.
What is the clove hitch knot used for?
A clove hitch is best used to attach a line (rope or cordage) to hand rail, stanchion, piling or to another piece of line.
It can be tied two ways, one is to take the line and form an "x" over a bar and bring the bitter end back through again or to form two half hitches in the hand and then slide them over an object such as a stanchion.
The clove hitch while one of the most useful and common "knot" known does have a tendency to slip in small types of cord. In wet line in can also become jammed. It is still a very useful knot.
Very commonly used by mariners to hang fenders, extra line and even tie off to a piling, it has a multitude of uses. Cowboys used a variation to tie their horse off to the "hitching" post.
Lastly the clove hitch should not be tied to square objects. Be sure you practice many times before using in a critical areas.
Why does a knot tied with jute thread not slip easily as compared to silk tread?
The fibrous surface of the jute thread has high friction, so the knot doesn't slip easily. Silk thread is smooth and has low friction, so the knot may easily slip - the same goes for nylon thread.
How do you choose the right knot for the job?
Practical experience is your best guide...
*Added - Training or experience is needed to identify the best knot based on 4 things - 1) Does its use weaken the strength of the line too much (some knots weaken line strength by nearly 50%); 2) Does it need to remain secure in all conditions (some knots can "spill", releasing them); 3) Does it need to be easy and fast to release (such as some sailboat lines); 4) Does it need to "look good" (ornamental or constructive knots)?
How do you tie a monkey-fist knot?
Take a piece of string, double it, pass one end of the string through the hole made by doubling it, and repeat.
* Added - The Monkey's Fist is very difficult to describe without a diagram - It consists of making 3 overlapping loops (look at the Ballantine beer symbol) - first make 1 circle clockwise, then double the circle laying the second line along the first; take the end, and now start an overlapping circle counterclockwise the same way above the first circle, over lapping about 1/3 of the circles; after the second strand is laid, go underneath the first circle and go to the left and alongside the first circle to make a 3rd circl, counterclockwise, with 1/3 overlapping both the 1st and 2nd circles; carefully pull the line tight and you have a Monkey Fist. This knot looks better and is more often done with 3 strands per circle.
The Monkey Fist was first described and named by E. N. Little in 1888. There are a few variations on the knot that are nearly the same, and some include using 4 or more circles.
