answersLogoWhite

0

Mazda Miata

The Mazda Miata is a two-seater Japanese convertible and the winner of the 2009 U.S. News Best Car for the Money Award. Ask your questions about the care and maintenance, stats, etc. of the classy and affordable Miata sports car in this category.

500 Questions

Where is the battery in a miata?

User Avatar

Asked by Wiki User

In the trunk to the right of the spare tire

Radio code Mazda 626 1993?

User Avatar

Asked by Wiki User

I found this online... it's worked on both 626 and Mazda 6. Worth a try.

Step one:- press one at a time - preset 6, AM, Auto M, Seek ^ (up).

Step Two:- Input this number, 4989.

Step Three:- Press and hold Auto M and Preset 6 together.

Step Four:- The Word ''GOOD'' will appear on the screen indicated that the radio will work.

Step Five:- Reprogram new Anti theft code into radio as per instruction manual.

How do you change the oil on a 1993 Mazda miata?

User Avatar

Asked by Wiki User

1. Raise the car on ramps or jackstands.

2. Remove the oil drain plug.

3. Remove the oil filter, located underneath the intake manifold. If you can't reach it from the top of the engine, you can remove the passenger side wheel (on a left-hand drive car), to reach it from underneath the fender.

4. Replace the drain plug.

5. Apply oil on the threads of the oil filter, and on the rubber O-ring of the filter.

6. Replace the oil filter on the engine.

7. Open the Oil cap on top of the engine.

8. Add 4 quarts of 10W-30 or 5W-30 oil.

9. Replace the oil cap.

10. Recycle oil

Why wont your clutch work?

User Avatar

Asked by Wiki User

my clutch went to the floor what happened?

Why do I get gas fumes smell in trunk and drivers compartment of my 91 Mazda Miata?

User Avatar

Asked by Wiki User

What you are smelling are the hyrdocarbons, which are the more damaging portions of gasoline to the environment. It may be a leak in the evaporative system, but being that you smell in in the rear of the car, it's probably the Charcoal Evap Cannister, or the hose leading to it.

The cannister is responsible for filtering out hydrocarbons from evaporating gas before it hits the air. If it's dead or not working this would be the fumes you'd smell. The cannister about the size of a golf ball and is typically hanging at the top of the rear passenger fender well.

Does a 1990 Mazda miata have an airbag?

User Avatar

Asked by Wiki User

yes, driver only

www.MX5unleashed.com

Where is the cruise module on a 1990 Miata?

User Avatar

Asked by Oldgolflover

Side of your steering wheel, and on the switch youll see stamped "CRUISE CONTROL" and "ON-OFF"

What is the size of the front speakers in a 1999 Mazda miata?

User Avatar

Asked by Wiki User

Standard 5x7 or 6x8 sizes will fit the Miata. Please note whether you have a Bose or non-Bose speakers when attempting to replace them, as it will make a difference in terms of the speakers you need to purchase.

Standard speakers use a 4-ohm coil, but the Bose speakers, common on most Miatas require 1/2 ohm speakers.

It is also possible to fit 8" woofers directly into the doors. Visit clearwateraudio.com for Miata-specific, aftermarket speaker solutions.

Tire size of 1999 Mazda Miata?

User Avatar

Asked by Wiki User

185/60r14

How difficult is it to change the alternator belt on a 1995 Mazda Miata?

User Avatar

Asked by Wiki User

Not difficult at all. You just need to loosen the tension bolts and pull it out.

DJ FLIP

Housepartykings.com

How do you remove the rear license plate panel the piece of plastic that the license plate mounts to on a 1999 4Runner?

User Avatar

Asked by Wiki User

remove the licence plate, open the tailgate, remove the cover on the pulldown strap, remove the 10mm bolt that secures the strap, remove the panel by prying one of the lower corners and then pulling the panel to release the plastic fasteners. push the panel up toward the top to release the panel from the gate. there is a black panel with about 10 10mm screws in it, remove them all then pull the panel away from the gate. let it hang on the wires attached to it, theyll be fine. inside youll find some studs protruding through, opposite where the panel is. remove the nuts on these also the nuts securing the tailgate lock cylinder, the wire connector on the cylinder, and the wire connector for the lic. plate lights. then (carefully!) take long needle nose pliers and release the plastic clips that hold the panel in place. there are like 6, they are hard as hell to get to and release for a first timer and if you break too many, you have to buy a panel to replace it!

What size speakers in a 1999 mx5?

User Avatar

Asked by Wiki User

Standard 5x7 or 6x8 sizes will fit the Miata. Please note whether you have a Bose or non-Bose speakers when attempting to replace them, as it will make a difference in terms of the speakers you need to purchase.

Standard speakers use a 4-ohm coil, but the Bose speakers, common on most Miatas require 1/2 ohm speakers.

It is also possible to fit 8" woofers directly into the doors. Visit clearwateraudio.com for Miata-specific, aftermarket speaker solutions.

Where can I find a used 1990 Mazda Miata on line?

User Avatar

Asked by Wiki User

There is a great website that has many listings for used 1990 Mazda Miatas. The website is Lemonfree.com and they have several listings for the 1990 Miatas.

How do you set cam timing on a 92 miata?

User Avatar

Asked by Wiki User

You can set the camshaft timing on your automobile by lining up the timing marks. There will be timing marks on the front main pulley and timing marks on the camshaft.

What does clatter mean?

User Avatar

Asked by Wiki User

clatter mean to be claterd to be stuck with a lot of people where u cant breath anymore

How do you get in the trunk of a 1991 Mazda miata without a key?

User Avatar

Asked by Wiki User

If you do not have a key to the trunk of a 1991 Mazda Miata, there is a way to get into it. You would (first) have to take off the back license plate. The lock sticks out about 2-3 inches. You would then have use a drill (electric) to unscrew 2 screws. This would take off the lock and let you into the trunk.

Where is the iat sensor?

User Avatar

Asked by Wiki User

it should be in the air intake box, i beleave on the right side of the engine compartment, or it may be before the box (the bit with the air filter) normally after or on the inside of the the filter.

Answerit is in the airbox. its the only thing on the airbox with wires connected to it. its removed by simply pulling on it. if your air box has a little hole in it, the sensor has been removed. look around the area for a couple of wires with what looks like a black plastic bullet plugged into the end of it. just stick the bullet into the hole and youll be fine.