Miscellaneous Vehicles

yes

about 16 medium sized ones

I know of no automobile that does not require a license to operate on public streets and roads.

JCB Pricing in India

JCB equipment prices in India can vary significantly based on factors such as the type of machine, model, attachments, and regional market conditions.

Backhoes: JCB backhoes in India typically range from ₹25 lakh to ₹1.5 crore or more, depending on the model and specifications.

Excavators: JCB excavators can range from ₹30 lakh for compact models to over ₹2 crore for larger, high-capacity excavators.

Skid Steer Loaders: Prices for JCB skid steer loaders start at around ₹20 lakh and can go up to ₹50 lakh or more, depending on the features.

Telehandlers: JCB telehandlers are available in various sizes and capabilities, with prices ranging from ₹30 lakh to ₹1.5 crore or more.

Is based on vehicle weight and road conditions.

you also have to figure in the reaction time of the driver, condition of the brakes, tires, and vehicle overall. however you can figure that at 60 mph a vehicle will travel one mile per minute

a smart car has 12 inch tires in the front and 12and 3 qutar inch in the back

Under the cab on the left

over a million for sure

The front and rear lights are tested to make sure they work, the steering wheel is turned to ensure the car can turn The tyres are tested to make sure they are inflated enough and have enough grip. The mirrors are examined to make sure the driver can see behind him.

Take all the belts off it first. The auger and drive are powered by the motor. The belt that powers the drive wheels will be closes to the motor and the belt that drives the auger will be closes to the auger. The space to attach the new belts will be on the motor side of the bottom pulley closes to the motor. Put the auger belt on the bottom pulley that's closes to the auger first but don't attach it to the top pulley. Next, put the drive belt on the bottom pulley closes to the motor- this belt can be attached to the top pulley closes to the motor. Now, the auger belt can be attached to the top pulley closes to the auger. Both belts have idler pulleys that keep them tight. These pulleys run on the outside of the belt. I use a bar when removing and replacing the belts inside of my fingers to guide the belts off the top pulleys. I make sure that the idle pulleys are the first and last that the belt gets attached to or removed from. These idle pulleys don't have to be removed for the replacement of the belts. I pull the starter rope slowly to help install the new belts. Remove the spark plug first. Accidental start ups can happen. The pulley/belt system can cause severe damage to your fingers- so don't use your fingers when guiding the belt on and off the top pulleys. Replace the belt guard if your snow blower still has one.

because ther skine

Yes it was a standard feature on 08 Outbacks.

It depends on how much snow you are going to blow. The more money you spend the more power you will get. I just purchased this and only used it a few times. It is going back to Lowe's and I am purchasing a Honda single stage instead. This Troy Bilt is rated to handle about 6 inches of snow and that is not an understatement. The Honda which costs considerably more, will handle 12 inches of snow and are known for their quality. I own a Honda Civic and a Honda self propelled smart start mower-both excellent. While many have said they have had no issues starting this machine, it took me a dozen or more pulls to get it started. With my Honda mower, it always starts on the first pull. Would rather pay the extra and get quality.

first check air filter if dirty. the spark plug is next crimped gas lines if that fails the carb is gummed up take carburator apart and soak it in carb cleaner.Fuel left in the tank over season will gum up the carb Replace all gaskets in carb

since sex was around

Transmission or linkage. If it's an auto, look under and see if it is actually in gear with a helper to hold the brake. If selector not moving trans selector, linkage needs adjustment. if in gear-check fluid. If manual, check clutch surface material.

1000 kilometers

scania is a auto makers. have bus and trucks

Depends what you want, power, economy or low $$$$

For power, go with a CAT

For economy Detroit S60

Dor low $$$ Cummins.

If the person turning left got there first, they should go first, if a car across arrives at the same time or before, that driver should go first.

four hours

sounds like youre spool lock is acting up for the bucket

suffocation