answersLogoWhite

0

Pontiac

This category covers questions about Pontiac, a subsidiary of General Motors. Pontiac was founded in 1899 and was phased out in 2010 by General Motors who wanted to focus on its other subsidiary companies in the United States.

1,501 Questions

Ac switch 2002 Pontiac has three prongs which two do you jump to get clutch engage?

Dont jump them, its not a switch, its a transducer and you could wreck your pcm by jumping the wrong one. Run a power wire directly to your compressor to get the clutch to engage. If it doent engage then, it is your clutch. Remember to first check refridgerant level and fuses/relays.

Good luck.

How do you remove the trunk lock of a 1971 Pontiac Ventura?

You have to open the trunk lid, under the lock on the inside you will find a screw, remove the screw and the lock retaining clip, pull the lock out. If you can not open the trunk lid, drill the lock center out, and you should be able to open with a screw driver.

How do you change spark plugs for 91 Pontiac grand prix?

how to chang spark plugs in a 1992 Pontiac grand prix

What type of motor oil for Pontiac grand prix?

For a Pontiac Grand Prix with a 3.8 L engine the factory recommends 5W-30, however during the winter months 10W-30 can be used.

Pontiac Grand Am 2005 engine diagram?

do you have a diagram for pontiac grand am 2005 thermostat

Where is the the oil dipstick on a 1998 Pontiac Grand Prix?

Front of the engine. It has a round yellow plastic handle to pull it out.

Pontiac G6 has check engine light with a wrench?

pontiac g6 check engine light car with wrench

How long has the Pontiac g6 been around since?

2004, with 2005 being the first model year.

Location of 1955 Pontiac brake master cylinder?

The brake master cylinder on a 1955 Pontiac is bolted to the frame rail under the steering shaft.

Vibration in a front wheel drive car speeds between 40 and 60?

you have a definete wheel bearing problem. have it replaced asap

My 1993 Pontiac grand am acts like it wants to go when i press the gas but also it almost dies this happens a few times while my foot is still on the gas then the car finally dies what's wrong?

There are many possibilities that could explain this senario. Intially you should make sure that your car has warmed up for atleast five to ten minutes. Pontiacs themselves are notorious for vacuum line problems. To no surprise in the recent recession Pontiac fell through. From here you should consult a friend or technician in regards to your fuel filter and or anything else with your fuel system. Before you do this you should use some lucas fuel treatment which will clean your fuel injectors and other important parts of your fuel system. If none of this information is of any assistance, consider your mass air flow sensor. This can be extremely expensive depending on your vehicle, but anything is better then going to a technician.

How many miles can you put on a Pontiac G6 motor?

I have 150k miles on mine and it is still working like the day i bought it

Why did my temperature light come on today. 1994 Pontiac grand am. The gauge did not say it was overheating and out of nowhere my car stalled and the red temperature light went on?

You have two different temperature sensors in your engine. One is connected to the gage on your dash. The other is connected to your car's computer. The one connected to your car's computer either malfunctioned or a wire leading to it broke. When that happened, it told your car's computer that the engine had overheated.

Where is the low coolant sensor located in a Pontiac trans sport?

that would be in the overflow reservoir follow the hose under the rad cap and you will see it

Your 2004 Pontiac Aztec service vehicle soon light came on what could be wrong?

it could litteraly be anything, from a bad sensor, to a stuck injector, to low air in your tires. have the code scanned, its cheap and can usually tell you whats wrong

Will a Pontiac hydramatic bolt up to a big block Chevy?

Assuming you are going back to the seventies, Buick, Cadillac and Chevy had the same bolt pattern. Then Pontiac and Olds had there bolt pattern. Breifly GM did supply hydramatic transmissions with both bolt patterns. So, if your transmission has more than eight holes ( two for the dowel pins) on the bell housing it should fit ether.