Savage Arms and J. Stevens

$5.00 U.S dollars you fruitcake

There may be a screw under the fore end. If so, remove it.

If there is no screw, or once the screw is removed, the fore end should pull away from the barrel, at its front. It may take some effort and may be held in place by spring tension.

Once it comes loose, the barrel can then be opened normally, and will dismount from the receiver pivot.

To reassemble, set the barrel in place, set the fore end against the receiver, and snap it back up against the barrel. Then replace the screw if there is one.

Try egunparts, on line auctions, gun shops, gun shows.

Between 120-150 dollars on today,s market.

It will depend on year and condition. However, Stevens are a reliable but inexpensive gun that typically are worth $75-$300 in 12 gauge double format, in 2012.

I would say between 1952-1953,with the serial number that you have provided.

Try gunpartscorp.com

I would start at Numrich Gun Parts Corp.

The Savage model 440 over/under 12 gauge shotgun will range in price from 250-400 dollars depending on overall condition.These shotguns were made from 1968-1972.

I can say that the Savage model 25 slide action .22cal rifles were made from 1925-1929.yours is some where in this time frame.

Depending on condition, average of $100 to $200 in 2012.

Your Savage model 775A light weight semi-auto shotgun was made from 1950-1965.

The Savage model 1895 was made from 1895-1899.There were approx.6,000 made during this time span.

I can't find any reference to a Stevens mod 320 however if it is similar to their mod 124 (12 ga, bolt action, 3 shot box magazine, 1950's manufacture) then you will not find an extended magazine for this gun. Stevens never made a 5 shot magazine for this gun and no after market companies would either.

A 12 ga pump with extended tube magazine is a better solution.

I would date your Savage model 99 to the year 1951-1952.

With the serial number that you have provided;your Savage model 99 rifle was made in the year 1925.

The value depends mostly on condition and what the gun actually is. Wards sold guns which were manufactured by several companies and generally sold the cheaper "plain Jane" versions. Their used value is not more than a few hundred dollars down.

If you mean "can I find the parts to install a pistol grip and vertical forearm onto a Savage model 30D 12 ga pump shotgun?" then the answer is almost certainly no. While the butt stock and forearm come off the 30D easily enough, the gun hasn't been manufactured since 1978. No company is manufacturing aftermarket parts for a 30 year old gun. Any such parts would have to be hand made.

Note: federal law requires a shotgun to have a minimum barrel length of 18", measured from the face of the closed breech to the muzzle, and a minimum overall length of 28"

Remove the butt plate by removing two screws. Look down hole in stock and see stock bolt head. Choose correct flat blade screwdriver to match the slot. Be careful to not break through thin wall of wood when removing stock bolt. When bolt is loosened, slide stock back off of receiver.

50-500 usd

All firearms that are in caliber .22 Long Rifle (LR) or 22 Long or 22 Short are rimfires. If you look at the face of the bolt, you can see the firing pin. If it is in the very center of the bolt face, it is center fire. If at the edge of the face, it is rimfire.

These will range in price from 175-350 dollars,depending on overall condition,and a good set of bores.

7

Yes you may use the 2 1/2in shells in your .410 gauge shotgun.

Clean the forward end of the chamber after shooting.

The Stevens/Savage model 987 was made from 1972-1989.