answersLogoWhite

0

What else can I help you with?

Related Questions

Can you remove the bellhousing from a FordOMatic 2 speed transmission?

no you can not. it is one piece


How do you remove applications on Samsung sch-r360 freeform 2 cell phones?

You can't! Very bad design. It's a piece of cr@p. You'll regret getting this out of date phone if you did.


How do you remove the spark plug cover on 2005 Hyundai accent?

Remove the 2 screws and take off the plastic piece.


How do you remove ice cream sandwich from htc sensation xe?

You have 2 choices: 1)Your carrier released a new version of android for your phone. 2)You root your phone and flash a different ROM into your phone.


What is the easy way to remove the rear driveshaft on a 1999 Silverado Z-71?

If it's a single piece driveshaft, remove the 4 bolts that hold the U joints to the differential pinion gear. If it's a 2 piece driveshaft, remove the 2 bolts that hold the center carrier bearing to the truck frame first.


How do you remove the back cover of a Samsung Galaxy Tab 2?

The back cover of the Samsung Galaxy Tab 2 requires a gentle push at the indent at the bottom of the phone. This then snaps the back case off the unit. Reassembly line up starts at the top.


How replace license bulb on clk?

open the trunk, then remove all the plastic snap fasteners (they are all 2 piece, remove the center piece with a flathead screwdriver and then once that is out, it looks like a plastic "nail", then remove the larger piece with a flathead screwdriver because the larger piece is actually snapped into the metal). there are about 8-10 of them. once you have them out the entire "carpet like" interior piece will come loose. You can then see up into the area where the license plate bulbs are and replace them. I just did it two hours ago. open the trunk, then remove all the plastic snap fasteners (they are all 2 piece, remove the center piece with a flathead screwdriver and then once that is out, it looks like a plastic "nail", then remove the larger piece with a flathead screwdriver because the larger piece is actually snapped into the metal). there are about 8-10 of them. once you have them out the entire "carpet like" interior piece will come loose. You can then see up into the area where the license plate bulbs are and replace them. I just did it two hours ago.


How many Flat surfaces and curved does a piece of paper have?

2 flat surfaces unless it is rolled up in which case it has 2 curved surfaces.


What type of case can I keep my palm pre in?

This website www.accessorygeeks.com Palm Accessories Palm Pre 2 Accessories would have the information you are looking for. I use a silicone case for my phone. It does not interfere with any of the functions on my phone.


How do you change a multi function switch on a 2003 Jeep Wrangler?

It is very easy... First...remove 2 Phillips screws which hold the lower plastic piece of the steering column...you do not need to remove this piece Next...remove the top plastic piece...easy plastic clips Now you see the multifuncton assembly...there are 2 wire connectors that need to be removed...first push back the little red locking clip...then remove the wiring harnesses Next...remove 2 Torx screws holding the assembly in place... Install the new assembly and put it all back together...should take about 30 minutes or less


Where can cell phone car chargers be bought?

Cell phone car chargers are found a lot of places these days. It would be good to buy a few at a time in case you lose one. There are sellers on Amazon that sell mobile phone car chargers that are 2 or more in a bundle and sometimes sold with a bonus case for your phone.


Does a galaxy note 2 phone case fit a galaxy note 1 phone?

No I dont think so. When I looked up the size of the Note 2 and the Note 1, the Note 2 is like .2 bigger than the Note 1. I've been having troubles finding a case for the Note 1 so I was just going to buy a case for the other one but they say its longer. I wouldn't trust it!