answersLogoWhite

0

you could try some how getting it covered in boiling hot water, or use a wrench, in desprate times I'd call for proffetional help.

Many times you need a chisel and hammer and just replace the plug

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you take a cap off of a sewer clean out?

Depends if it is a cap or a plug or no hub or a brass /lead plug


What is the purpose of a sewer line cap and how does it function in a plumbing system?

A sewer line cap is used to seal off the end of a sewer line to prevent leaks and blockages. It functions by securely covering the opening of the sewer line, preventing sewage and odors from escaping and keeping debris from entering the system. This helps maintain the integrity and efficiency of the plumbing system.


How do you install a rotor cap in a Chevy Silverado?

all you should have to do is take the distributor cap off, and there it is. answer take the distributor cap off, pull the old rotor off, put the new one on, put the cap back on.


When the engine has cooled off will you still have pressure from the radiator cap when you try to take the cap off?

no


Do you take off the cap of a lava lamp?

No you do not.


How do you do level 30 in factory balls 3?

1.Put in red 2.Put on cap 3.Put in chemical 4.Take cap off 5.Rotate five times 6.Put on cap 7.Put in chemical 8.Take off cap 9.Rotate once 10.Put on cap again 11.Put in chemical 12.Take off cap 13.Rotate twice 14.Put on cap 15.Put in red 16.Put in chemical 17.Take off cap AND YOUR DONE


The toilet and bath are cloged- took the cap off the tube outside and toiledt water gushed out. how do i fix this?

If you are on city sewer, the line to the sewer is either clogged or collapsed. You will need to have a plumber check it out. If you are on a septic tank, it may be full and need to be pumped out.


How do you take a single handled faucet off a bathtub?

You have to pop the cap off on the front of the acrylic handle, then under the cap there will be a screw to undo.


How do you take a radiator cap of a 2000 Oldsmobile silhoutte?

Do not take a radiator cap off. Fill from the overflow tank or you will add air to the cooling system and it will have to be bled off or your engine will overheat.


Car not starting unless you take the gas cap off?

Vapor locking ...try a new cap


How do you take off radiator cap off 2004 Pontiac prix?

use a chainsaw


Where is the oil cartridge located 2008 g6?

On the 4 cylinder, Take off the plastic accoustic engine cover ("ECOTEC" on it, and take off the oil filler cap first). It just pulls off once the oil cap is off. Then look down where the dipstick is, there is what looks like a PVC pipe drain plug for a sewer drain in your basement. That's the cap to the oil filter. You'll likely need to bend a wrench or go out and buy an appropriate crow's foot to get in there but removing that cover will reveal the paper cartridge. It's a dry sump so there shouldn't be any oil in there and the cartridge will be only a little damp.