Open trunk, plate fits through a slot--just push up from the outside front of plate
Remove the plastic covers around the steering column. Remove the panels by knees and feet on driver's side. You'll need a Torx bit to remove the Signal switch, follow the path and disconnect wire connectors. Retrace steps to install new switch. All in all, was pretty simple. ~Dawg
I am locked out of my Buick park avenue and have a slim Jim but don't know how to use it
1960 Buick Invicta
MuscleCar - 2001 Blue Collar Buick Paint was released on: USA: October 2010
The Car Coach - 2011 2012 Buick Regal was released on: USA: 24 November 2011
You must remove the entire tailight panel - remove trunk liner and the recessed nuts.
If you can not remove fasteners from outside of trunk you must make a cut-out inside of trunk so you can get your hand to access bulbs.
If it's like my 2000, you remove the plastic splash pan under the engine (27 pop outs and 5 screws) and then you can just twist and remove the bulb holder. Recommend unplugging bulb holder and cleaning all contacts.
how do you change the rear license plate light on a 1999 Buick Regal
If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.
how do I remove the sunvisors off a 1999 Buick Century
How do you remove 1998 Buick regal ls sun visor
You cannot remove what it does not have. Your Buick does not have a governor. Speed is controlled by the ECU.
how do you remove left rear door panel on a 2008 buick lucerne cxs.
you have to remove it
How do you remove steering pump on a 2002 Buick rendezvous 3.4L?
=== ===