0
Can you Show picture of cam shaft sensors for Dodge 2002 Intrepid?
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Are there two cam shaft sensors on 2006 dodge stratus with a 2.4l?
No, just one.
How can you tell if the crank shaft pulley is broke in a 2000 Dodge Intrepid 2.7 liter 6v engine?
Take It Off Amd Inspect It.
What is the pulley for your timing belt directly behind the crank shaft called on a 1997 Dodge Intrepid 3.5L V6?
Timing belt crank sprocket
Dodge Dakota crank sensor what is it for?
most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.
Can you show a picture of the nose of the crank shaft for 2005 dodge ram 4.7 1500?
Sorry, this is a question and answer site not a picture site.
Will not crank no fire codes OK coil OK 96 Dodge Intrepid 3.5 what to mlook for?
try crank position sensor and cam shaft sensor
How do you replace the cam shaft sensor in a 1998 Dodge Intrepid?
buy a new one or junkyard drop it in and start it up its got a paper spacer so make sure its there
What tools can you use to pull out a crank shaft pulley for a Dodge Intrepid 2002?
3 JAW PULLER. (You can buy it at any autozone, CAP or NAPA) $10.00 - $20.00 bucks.
How do you remove the harmonic balancer on a 1996 Dodge Intrepid?
Hi The 3.5L has a tapered shaft, you MUST use a balancer puller or you will damage the pulley. These pullers are under $30 bucks
What does a dodge intrepid input and output sensor do?
The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.
Air is only coming out of defrost vents no matter what setting air conditioner is on in my 98 Dodge Intrepid.?
Sounds like the switch broke (the one that directs the air valve) or disconnected somewhere along the shaft.
Where is the camshaft position sensor located on a 1999 Dodge Intrepid 2.7 and what do you have to do to change it correctly?
It is on the left front of engine. Points at the left front cam shaft. UNplug the wire , unscrew bolt, and pull sensor out.
