Thermostat Removal & Installation 1. Disconnect the negative battery cable. 2. Drain and recycle the engine coolant. 3. Remove the Power Steering reservoir support bracket. 4. Remove the upper radiator hose at the thermostat housing. 5. Remove 2 thermostat housing retaining bolts and remove the housing. 6. Remove the thermostat and O-ring from the lower intake manifold. Discard the O-ring. To Install: 7. Clean the O-ring sealing surfaces. 8. Install a new O-ring, on the thermostat and position the thermostat in the lower intake manifold. 9. Place the thermostat housing on the lower intake manifold and install 2 retaining bolts. Tighten the bolts to 15-22 ft. lbs. (20-30 Nm). 10. Install the power steering reservoir support bracket. 11. Fill the engine cooling system. 12. Connect the negative battery cable. 13. Start the engine and allow it to reach normal operating temperature while checking for coolant leaks. 14. Road test the vehicle and check for proper engine operation. 15. Check the coolant level and add if necessary.
Please help me!!!!!
Follow the top radiator hose to the thermostat.
How do you fix the cable in side of the back doors of a 2000 ford f150
Find the thermostat at the engine end of the upper rad hose. When you replace it , make sure the spring goes toward the engine.
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
deep well 9/16 or 1/2 inch pay attention to replaceing thermostat spring side up
Replacing the thermostat in a 2000 Ford Focus SE wagon is very easy to do. First the radiator hose will need to be disconnected from the thermostat. After the hose is drained and disconnected, the thermostat can be removed by taking the two bolts off.
how to change a thermostat on a 2004 ford expedition
how do you change a thermostat for a 1997 Ford Contour
How do you remove and replace the battery on a 2001 Ford F150?
Orifice tube on f150 with 4.2
( 6.0 quarts ) with filter change ( according to the owners manual )