You may get an answer if you list the vehicle & engine you are talking about. You are not going to get an answer to this question as is.
You can change the serpentine belt by loosening the tensioner pulley. When the tensioner pulley is loose and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.
I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine There should be a sticker near radiator shroud that has belt routing. If not stick the belt down past the right side of fan/water pump .put belt on crank pulley then pull back of belt over water pump and then down around power steering pulley and up over compressor pulley. put belt from crank pulley around smog pulley then up to tensioner with back of belt around tensioner and then around alternator pulley.next put rachet and socket(15 mm) on tensioner and pull on it while placing belt under idler pulley.
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
You will need to loosen the tensioner pulley. Slide the tensioner pulley to the right and the serpentine belt will become loose. Remove the old serpentine belt and put the new serpentine belt on. Slide the tensioner pulley to the left and tighten it.
looking for a belt diagram for a 2005 Mercedes c230 kompressor supercharged
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
There should be a belt diagram under the hood.
picturediagram of how to install 89 Cherokee serpentine belt
Loosen the tensioner pulley on your Monte Carlo 3.1 liter engine. Slide the tensioner pulley to the right. The serpentine belt can be removed. Put the new serpentine belt on and slide the tensioner pulley to the left.
There should be a diagram on the underside of the hood.
Begin by loosening the tensioner pulley. Slide the tensioner pulley to the right. The old serpentine belt will become loose and can be removed. Put the new serpentine belt on and reverse a process.