I want to elaborate this hole is below the crank, the crank chamber does not hold pressure and does not hold oil. so can i put a weld patch over it and call it done?
there is a wall between your trans part and your bottom end where ur crank is. If it is not leaking out of the outer case, then i dont know because it wont be getting past the wall unless it has a hole in the wall... and u will know if that has happened.
Cranks and turn over are the same thing. It may crank or turn over and not start. If that is the case, find out if it needs fire or fuel and go from there.
You need to bclear, does it crank or not crank?----for starters.
Not unless you were born with a hole in your heart. There's a 50% chance but probably not. Just in case you should get x rays
take the plug wire off one of the plugs leave it in the hole have somebody crank the engine listen for the spark tick should be very loud do this on all four cylinders one at a time if you have no spark on any of the cylinders it is the crank sensor
the oil is called type F it was originaly made for ford motors but most people put it in the blaster
23.67 ozs and I use Spectro Clutch Saver 10W 40
probably has low compression
a hole in one of the pistons
haha same on my cr125
Ive ran into this problem. It could be one of two problems, but what i have that it could be a bad crank seal or there is a crack in the case. First check the crank seal if it is good then you need to split the case and find the crack. JB Weld will fix it right up.
Easy way to check if the level is correct is to remove filler cap take your pinky finger stick it in the oil filler hole to the first knuckle. remove finger the very tip of your finger should have oil on it. If not add alittle.
i would assume you have cranks with a built in sprocket, if this is the case, you can't
It does not have a crank case sensor.It does not have a crank case sensor.
i have a 1986 Toyota 4x4 auto 2h diesel with electric and hand crank if battery is flat it has a special radiotr with hole in it for crank handel
Where is the crank position sensor hole on a 2003 Blazer
on top of the crank case towards the outside , it vents into the carb by vacume.