To fix it do this : say the drivers side blinker goes on and does not flash. Well then you have either the front or rear blinker burned out. Thx KB
There's the possibility of burned bulbs, but if both sides fail to blink, replace the flasher unit.
You probably have a burned out bulb. The turn signals both use the same flasher.
It is either a blown fuse, defective Flasher Relay, defective turn signal switch, blown bulbs, or loose or corroded bulb socket. If none of the turn signals flash, then the flasher is bad. Replace it.
If one turn signal is flashing fast it is to warn the driver they need to replaced either the front or back signal bulb.
Probably need a new turn signal bulb.
No. there is no relay for the turn signals.
change the flasher relay
add a faster relay
replace turn signal flasher, hazard flasher is separate
4 way flashers and turn signals both have a "flasher can" in the system to make the lights flash the turn signal and 4 way flashers are controlled independantly of each other try replacing the flasher can for the 4 way flashers it is obvious that the bulbs are ok because they work on turn signals
It could be as simple as a fuse. Or as hard as a multi-funtion switch. Which means the switch for your turn signals.
One of your turn signal bulbs is burned out. Either the front or the back.
check you light bulbs