0
How do you get the ignition out of a 96 Ford Ranger with airbag?
Wiki User
∙ 18y ago
Turn key to run position. Below steering column is hole directly below ignition. Insert small screw driver and press putton with it. Pull put in ignition.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How many plugs 96 2.3 ranger?
The 1996 Ford Ranger 2.3 L engine has Fords Twin Plug ignition system , so it has ( 8 spark plugs )
What are the causes for no heat problems on a 96 ford ranger?
no heat in 96 ford taraus,new thermostat,has coolant in it
How do you change a fuel filter on 1996 Ford Ranger supercab?
where is the fuel filter located on 96 ford ranger supercab
What is interchangeable with a 1996 Ford Ranger?
a 96 Mazda pickup
How do you adjust a clutch on a 96 ford ranger?
it is hydraulic. there is no adjustment
How much does a 1996 Ford Ranger weigh?
A '96 ranger weighs around 3,245 pounds
Will a 87 ford ranger transmission fit into a 96 Mazda b2300?
What make and model ford 6 cyc will fit 96 mazda
96 ford ranger what type of spark plugs should i use?
Motorcraft is best for Ford
What is the horsepower in a 2.3l manual transmission on a 96 Ford Ranger?
For a 1996 Ford Ranger , 2.3 litre four cylinder engine ( 112 horsepower from the factory )
Where is the airbag located on a 96 ford telstar drivers side and what does it look like?
The driver airbag is always located inside the steering wheel.Look at the steering wheel cover for the letters SRS or the word "AirBag".If the airbag does exist,you will see that written.
What does airbag code 52 mean for 96 ford windstar?
The airbag code 52 on a 96 Ford Windstar often means nothing more than that there is a loose connection in the electrical system. The code can be reset by disconnecting the battery for about 10 minutes, then reconnecting it. If that doesn't work, the code may also be indicating that the airbag itself is not getting power and requires servicing.
How do you install a lift kit on a 96 ford ranger?
The kits usually come with instructions
