Raise the hood and look at the top of the metal cross member that holds the radiator and fans and head light housings. Right next to the very front fender on both sides of the vehicle and at the top of the head light housings, you will see a small 7mm silver screw and right across from it and on top of the head light housing, you will see a second 7mm silver looking screw. These screws hold the head light housing to the metal cross member. Remove the two screws and the head light assembly is easily pulled forward enough to allow removal of the lamps. The lamps have a locking tab on the plug assembly. Just press the plastic tab and turn the lamp socket counter closckwise to remove it from the lamp housing. Now, the lamp can be pulled from its socket holder. Don't touch the new lamp with your fingers or it will cause the lamp to turn dark and shorten its life. Assemble in the reverse order.
You don't.
A 2002 Chrysler Sebring was not built with a cabin filter.
A 2002 Chrysler Sebring convertible does not have a maf sensor.
No, in 2002 the Chrysler sedan was a Sebring.
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.
No.
No
I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.
The 2002 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column
It does not have one.