Pull out the ashtray and then the panel above and the cup holder . Radio will then come out
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.
It extends and retracts the radio antena when you turn on your radio.
Clarion. Check this out: http://elrocco.com/integration-of-an-ipod-in-a-2006-subaru-impreza-25i
No, the radio has its own built-in amplifier. If you're not getting sound from ANY speakers, your radio is probably broken and needs to be replaced.
Remove the retaining cover to your 2005 Chevy Malibu radio. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable.
The rear defroster (demister) on a Subaru Legacy is built into the window. The lines going across the back window are actually the defrosters. If the vehicle is equipped with a rear wiper, the switch for this should be located below the radio and heater controls.
you eat it
If you are referring to the factory supplied radio, it is not a 'component' type radio. It must be removed from the dash and dis-assembled.
battery
There is a frame around the radio that can be remove with a screw driver. Once this is remove you will be able to see four screws that need to be removed.