0
On the top of the dash there is the little strip. Mine hase two little speakers on each side. You can just lift up on the strip its just held down with some clips. under there are some bolts that hold down the top part of the dash. so that's about as far as I went. All I had to do was take out the radio to install some speakes and an amp. I installed a hi/low adapter for the amp. So there is a little screw in the little box. You remove that screw pop out the little tray. then you can pull out the rest of the trim around the radio. snaps hold that in as well. there are 4 screws that hold the radio in. remove those and then there you go. you can access the radio harness from there. now this was tha hrd part for me I had to go to a local sterio store to get a conversion after market harness to match up the the original one in the Jeep. after matching the harnes up the color code is like this:
Blue/White- Rear Right +Blue/Orange- Rear Right -
Blue/Grey-Rear Left -Brown/Yellow-Rear Left +
Purple (solid)-Front Right +Blue/Red- Front Right -
Brown/Red Front Left -Green (solid) +
The ones above are clustered together one one side. There is some blank spaces between the left and right bunches.
Orange-IlluminationGreen-Power Ant.Red/Orange- 12 volt PowerPink(there is 2 of them doesnt mater which one)- Memory
Hope this help. It took me all day to get all this done to my jeep
Wiki User
∙ 12y ago
Wiki User
∙ 15y agoIf I'm not mistaken there's bolts inside the console under the rubber mat and under the rubber mat in the cup holder area and the little storage compartment My 05 Expedition has the same bolt/screw under the mat. After removing it, I had to pull the top section (the compartment that you took the screw out of and the cup holders) out, it was kinda tuff, but there are six spring clips that continue to hold the top to the bottom of the console. One at each of the corners, and one on each side of the center of the console, where it makes the bend.
Wiki User
∙ 16y agoMy vehicle has a standard transmission, the gear selector on an automatic will likely make it more complicated. First remove the trim from the stereo bay. there is a screw behind the ash tray. The trim should pull off now. It shouln't take too much force to pull off, but more than a gentle pull will be necessary. Then remove any screws you can see holding the stereo in. Remove the screws that are forward near the floor on either side of the console. Remove any other trim panels that may be holding the top edge of the forward center console in. Then lift it up. There are 2 screws underneath it that are holding in the back center console. Also remove the 2 screws inside the compartment. Your center console should pull out now. Again, don't force it too hard. If it won't come up, I probably forgot to tell you about a screw or two.
Wiki User
∙ 15y agoopen the console door and start taking out screws in the base and then there should be a couple of screws under that console door that hold the top of the console on, take them out and then when you lift the top of the console up you will see all the screws that hold it to the floor.
Wiki User
∙ 9y agoRemove the shifting knob. Remove the center console cover retaining screws. Remove the retaining nuts from the floor. The center console will come out.
Wiki User
∙ 13y agogetting the center console out of a 2005 caddillac escalade
Wiki User
∙ 15y agoThere are 3 screws, one in each cup holder
Add your answer:
Earn +20 pts
How do you remove the center console of a 1999 Nissan Altima?
The center console is held in place with for retaining bolts. The retaining bolts are underneath the carpet. Pull back the carpet and remove the bolts. You will also need to remove the shifter knob.
How do you remove the center console to replace the climate control functions on a 1999 Hyundai Sonata?
hard work
How do you remove the stereo from a 1999 Honda Civic?
To remove the stereo off of a 1999 Honda Civic loosen all of the mounting screws for the center console. Pull out the console is loosen the stereo mounting screws. With everything off pull the stereo and unplug the radio.
How do you open center console on 1999 dodge ram?
put center console on down position and press button on side then open.
How do you remove center console on a 1999 camaro?
Open the console door and start looking for bolts that need to come out that hold it to the floor, also the top plate of the console will have to come off and then you will see all the bolts that need to come out to take it out.
Where is the airbag module on a 1999 Lincoln continental with a center console?
seven.
Where is the CD changer in your 1999 ford windstar?
The CD changer is in the center console of a 1999 Ford Windstar
Location of the BCM in a 1999 Yukon?
Under the black rectangle in the middle console right above the 2 cup holders. Remove the rubber lining inside the cup holders to reveal the screws that hold the center console in place...
How do you replace the heater core in a Opel Astra 1999?
To replace the heater core in a 1999 Opel Astra, remove the center console and remove the 6 5.5 mm bolts. Also remove the clips and remove the cover and plastic clips on each pipe. Finally, lift the heater core and replace with new.
Where is the transmission pump 1999 Sable?
If you have the metric trans, the pump is in the top of trans body, near to the engine. You must remove trans to get at the pump.
What are the wiring connections for the overhead console of a 1999 Dodge Durango?
The 1999 Dodge Durango overhead console wiring connections are beneath the overhead console. You will need to remove the overhead console?æin order to access the wiring connections.
How do you replace the shifter light in the center console of a 1999 Honda Civic LX?
The shifter light on the center console of a 1999 Honda Civic can be reached by removing the center console assembly. Loosen all of the proper screws and pull off the assembly. Once the bulb is visible replace the unit using an appropriate sized bulb.
