The gasket is probably hardened to the pan and the block. Use a 1" putty knife to wedge it between the pan and block. This should break the seal.
Remove the third bolt !!
After removing the 2 bolts...remove the side marker light as well, then slide the headlight assembly toward the fender(about 1") then pull towards you, to release it from the frame. It should pop right out on top of you.
apparently there are 4 bolts at the flywheel end inside the clutch housing. You must remove the gearbox from the engine to access them! good luck all
A three jaw puller is the proper tool. I have removed over 100 that way.
The population of Budge Budge is 75,465.
Budge Budge College was created in 1971.
If a few good strikes with a hammer doesnt release the assembly an air chisel will easily.
Just your fingernail. If it won't budge try using some silicone dry lubricant from a bike shop.
the fan has left hand tread.try turn it in a clockwise direction to remove it
hi people i have a Toyota selica 98 mod ... i need to remove my bk brake disk it wont budge iv loosened the hand brake and removed calloper ???any ideas thanks odbod
He would not budge to let them in. They would not budge from their position on the issue.
Tom Budge's birth name is Thomas Budge.