answersLogoWhite

0

How do you replace Mazda 626 thermostat?

Updated: 10/25/2022
User Avatar

Wiki User

15y ago

Best Answer

locate the thermostate on the lower rad hose as it enters the engine block. Remove the 2 thermostate mounting bolts and remove the circular thermostate. Installation is the reverse of removal. Ensure you obtain a new gasket prior to installing the new thermostate.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace Mazda 626 thermostat?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat located on a 1999 Mazda 626?

Where is the thermostat located on a 1999 Mazda 626?


How do you change thermostat 2002 Mazda 626 V6 2.5L?

Where is the thermostat located on a mazda 626 2002


How do you replace the thermostat located on a 1999 Mazda 626 V6 and show a diagrahm?

it is the same for all Mazda with a v6


Where is the thermostat located on a 99 Mazda 626 2.5l V6?

the thermostat on a Mazda 626 is vey difficult to find i replaced it myself and i found out it was right under the air filter box.


Numbering ignition 1998 Mazda 626?

How do I replace ignition wires on my 98 Mazda 626 2.0L


How do you replace the thermostat located on a Mazda truck?

how do replace the thermostat on a 1999 mazda b2500 truck?


Will a bad thermostat cause a mazdA 626 to run hot?

Yes It Can.


Where is the thermostat on a 1999 Mazda 626?

where the lower rad hose meets the engine block how do you change a thermostat on a b2500 mazda pick up


How do you replace a thermostat in a 2000 Mazda 626?

Follow the TOP radiator hose to the engine block Remove the hose from the engine block. Thermostat should pop out. Some screw in, most pop out.


How do you change the engine thermostat in a 1996 Mazda 626?

It is located at the engine at the upper rad hose, When you replace it, make sure the spring goes toward the engine.


Where is the thermostat and how do you replace on a 1999 Mazda 626?

I don't know about the 4 Cylinder, but the 2.5L V6 1999 626 has the thermostat on the lower hose area, where it attaches to the engine/thermostat housing. To replace it, I had to take the entire air box out. It took a bit of work. You also need to take off the heat pipe mount attached to the engine in order to pull the thermostat housing apart.Not the easiest job for a thermostat replacement.


Where is the thermostat located on 1997 Mazda 626?

According to Haynes Repair Manual #61042 for the years 1993 thur 2001 fot the Mazda 626 & MX-6 Ford Probe the engine thermostat is located on the driver's side of the engine compartment under the air breather. It is necessary to disconnect the ram-air hose & remove the air-filter compartment to reach the thermostat. The thermostat is held in place by two bolts & an "O" ring gasket. I had to replace mine & is took a "little while" to remove everything to get to the thermostat, replace the thermostat & then replace everything back in place as it was before.