answersLogoWhite

0


Best Answer

Remove the antenna and the coax and where the coax was route the new coax in the same places and runs where the old was and replacw with new and then screw the new antenna back on

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the antenna and coax in a 2000 Chevrolet Silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Door latch diagram for 2000 Chevrolet silverado?

door latch diagram for 2000 Chevrolet silverado


How do you remove the headrest off of a 2000 Chevrolet Silverado?

How do I remove the heatrest off of a 2000 LT Chevrolet Silverado


How do you replace a car antenna wire on a 2000 Chevrolet Tracker?

If it is electric, take it off and then take it apart and install the ant.


How do you replace window cable on a 2000 Chevrolet silverado pick up truck drivers side?

The cable runs through and is coiled inside the motor. It is advised to replace as an assembly.


Why does your horn not work on your 2000 Chevrolet silverado 1500 pickup?

fuse


How do you replace the ambient light sensor on a 2000 silverado?

how do you replace ambient light sensor on 2002 silverado


How do you replace 2000 silverado 4x4 pitman arm?

How do you go about replacing the pitman arm on a 2000 Silverado?


Will 15 inch wheels fit on a 1999 Chevrolet Silverado?

Will 15 inch wheels fit on a 2000 Chevrolet Silverado? NO THEY WILL NOT. They will hit the brake cailbers, won't fit.


What is P0160 on 2000 Chevrolet Silverado?

02 Sensor, bank 2 no activity.


Where on a 2000 Chevrolet Silverado is the emergency shut off fuel switch?

There is NOT one.


How do you replace the clutch pedal bushings on a 2000 Chevrolet Silverado 5-speed manual transmission?

They are easy to replace but hard to get at under the dash. Sinply remove the pin holding the pedals in and the rods to the cylinders and the pedals will comeout.


How do you change the shaft seal on the air conditioner compressor on a Chevrolet Silverado 2000?

Usually the shaft seal is installed from inside the compressor housing and is not serviceable. You would need to replace the compressor.