The bulb assembly needs to be removed from the front of the vehicle. Open the hood, and you will see that the entire plastic headlight assembly is held in place by a few hex head screws. Once these are removed the entire assembly can be lifted out, giving you access to the lamp socket. Replace the lamp (bulb)and reinstall. NOTE _ Be careful not to drop the screws in between the radiator and the grill, as they are hard to retrieve and usually get stuck on the body panel below the bumper. **you can actually avoid taking out the entire headlight if you just remove anything in the way of reaching behind the assembly. on the right side, it would be the fuse box, on the left side you can probably just reach behind if your hands aren't too large. then remove the rubber seal by prying it off. there is a spring clip that holds in the bulb, remove that by sliding it out from behind the bulb, then remove the bulb and replace.
Step1 Shut off the Camry's engine and set the parking brake for added safety. Also, make sure its headlights are switched off.
Step2 Open the hood using the primary and auxiliary hood release latches.
Step3 Locate the back of the headlight assembly and determine whether the low- or high-beam bulb needs to be replaced.
Step4 Turn the headlight bulb socket counterclockwise to remove it from the assembly.
Step5 Unplug the electrical connector from the back of the bulb. Carefully dispose of the bulb to prevent it from shattering or cracking.
Step6 Attach the electrical connector to the new bulb and insert it into the headlight assembly. Twist it clockwise to secure its position.
Step7 Test the new headlight to make sure it works before closing the hood.
check for bare wires or short in the wiring to the rear lights
Any Prizm or Corolla auto trans from 93 to 97. The 1.6 or the 1.8 housings are all the same. Just make sure if it is a 3 or 4 spd auto. It is a 6 hour job.
4 quarts
I would recommend 5w-30
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
the headlight assembly needs to come out in order to change the bulb ive had to do that to my 98 as well.
yes
It is behind the headlight on some cars.
It is located under the hood inside the radiator hose.
Type your answer here... where is the coolant sensor ona 2001 chevy prizm
I believe that it is under the radio in the dash
Go to your Chevy dealer parts department; they can print a copy for you.
It is located inside the gas tank. Dealer once quoted $500 to replace the entire tank unit. It is located inside the gas tank. Dealer once quoted $500 to replace the entire tank unit.
i http://wiki.answers.com/Q/You_went_now_where_thermo_located_in_chevy_prizm_2001
The fuel filter is located inside the tank.
it is located under the dash behind the glove box. there are 2 bolts hold it in place. remove the wire connecter and the 2 bolts and slide it out.
it is located under the dash behind the glove box. there are 2 bolts hold it in place. remove the wire connecter and the 2 bolts and slide it out.