0
It should be on the fan shroud. If not, draw one before you take it off. If it is off, go to a used car lot and find a car like yours and draw your own schematic. Or it is in your owners manual or get a manual on your car from the parts store.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you route a serpentine belt on Olds Cierra 1992?
How do you route a serpentine belt on a 1992 Cierra Oldsmobile
How do you route the serpentine belt for 1998 BMW 5 series?
How do you route the serpentine belt for a 1998 w
How do you change the serpentine belt on a 1989 Cadillac Eldorado?
How Do I change the serpentine belt on a 1989 Cadillac Eldorado ?
How do you Install F250 serpentine belt?
how to install a serpentine belt on 1989 f250 diesel 7.3l
Route for serpentine belt on 1994 Dodge Spirit?
serpentine belt routing diagram for 1994 dodge spirit
Where can I find a diagram of the serpentine belt for a 95 beretta?
you can find alot of answer from out of a haynes repair manual
Does a 1993 Jeep Cherokee Country have a separate belt for the air conditioner or does it run off the serpentine belt?
A/C Condenser is on the serpentine route.
How do you route serpentine belt on 1997 Mazda B2300?
you start by putting the belt on from left to right.
How do you route serpentine belt for 1992 Lexus?
There should be a diagram on the underside of the hood.
Serpentine belt route for a 2007 dodge 3500 diesel?
A 2007 Dodge 3500 diesel engine serpentine belt routing diagram can be obtained from most auto-parts stores. When you purchase the serpentine belt, ask for a routing diagram.
When changing the serpentine belt on a 1989 Thunderbird supercoupe how do you get past the radiator hose. Or how do you get off the serpentine belt?
you have to take that bottom radiator hose off to replace it
How do you get the accessory drive belt or serpentine belt off of a 1989 sunbird?
To remove the accessory drive belt or the serpentine belt from the motor on a 1989 Sunbird, it is necessary to loosen the belt tensioner. Look for a pulley that has a bolt in a slot. Loosen the bolt and move the tensioner so there is a gap in the belt. Then remove the belt from each pulley.
