Hold the clock button in until the display flashes the time. Then use the channel changer button to set the time. FYI: The minutes are adjusted by pushing the right side of the button, then the hour is changed by pushing on the left side. After you get to the correct time, push the clock button again.
Yuo hold down the clock button and press up on tune to change minutes and down to change hours
don't just press the buttons hold them down until the nuber changes
The radio and clock might be flashing on a Kia Sephia if a wire is loose. There might also be a short in the wiring for these two items. Sometimes the clock will flash if the battery was unplugged for a while to let the driver know to reset the clock.
Nothing,
Push the clock button, then push the tune button. Up for minutes. Down for Hours.
hold clock button and use the seek or other button underneath while holding the clock button
assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it
Press and hold the FM/AM button (Clock is printed above the button) to begin setting the time. After a couple of seconds the time display will begin flashing and you'll hear a beep; once that happens, let go of the button.
If by the clock you are talking about the one on the radio it is very simple. 1st> press and hold in the clock button for about 5 seconds 2nd> while still holding in the clock button press the SEEK button for the hours and the SEARCH button for the minutes. 3rd> release the clock button and you are all set
To set the clock on an Emerson microwave oven, tap the clock button and then hit the numbers according to what the current time is. Then tap the clock button again. If the numbers go back to 000, then there is a malfunction with the clock on the microwave.
Here's how to set the clock: Press and hold the select button for a few seconds, once it changes screens let go and tap the station search button until it says clock H...Then do nothing!!! Just wait...In a few seconds the clock will appear and the hour will be flashing. Use your station search buttons to set the hour. Press select button when done. Then do it again and select Clock M and repeat the process to set the minutes.
you can't. I've tried. a lot. probably too much. NOTHING happens.