I would suggest you invest in a repair manual. It cost around $12 at most auto parts stores, and will contain the info you need to complete this repair and many others. It will pay for itself with this one repair
disconnect the battery, remove the bolt in the center of the pulley, then use a harmonic balancer tool to remove it
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
take off the belt, use a pulley puller to pull it then reinstall.
usually behind the crank pulley, if you take the passenger side wheel off you will be able to see part of the pulley, very bottom one.
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
You need to take your crank pulley off the plastic cover and your there
I want to take off the pulley wheel off,from a 1992 chevy lumina apv van.
take off the serpentine belt and crank pulley and you will need a harmonic balancer pulley to get it off.
The crank is where the engine power comes out. The pulley, with its belts, let you take some of that power to run other things, like water pump, alternator, a/c compressor and things like that.
that year did not take one
Remove the radiator and the clutch fan , Then remove the belts .You will have to loosen Alternator and the A/C compressor to do this . On the crank pulley there is 5 small bolts (8mm) around the inside of the pulley. Take them out . Then remove the pulley . Take the bolts out of the Timing cover and remove it . Under it you will find the Timing belt . It has a Tenisioner that has to be loosened . FIRST if possible align the timing marks . before removing the belt . This can be done by turning the large bolt that is in the end of the crank. . But if the belt is broken or damaged . Align the bottom pulley key way with the mark on the oil pump 12:00. . and the top pulley with the notch in the metal plate that is behind the top pulley . 12:00 . Install the belt. Then tighten the tensioner. reassemble in reverse order
its located on the front passenger side of the car.first take off the tire,then the inner fender and the crankshaft pulley will be right there. its also easier to do with air tools.