there should be a tesion pully that needs to be loosened
how do you install a serpentine belt on a 1996 corsica?
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
how do i find the auto tension release for the serpentine belt on a 2004solara
The tension on a serpentine belt is automatically set by the Idler Tension Pulley. If you find it is not correctly setting the tension, the the spring may be broken.
Most serpentine belt systems have a self adjusting tensioner.
The zd30 has a hydraulic tensioner using an idler pulley to automatically tension the serpentine belt.
there's a spring loaded tension-er on the right side of the engine.. look at your belt diagram on your engine and you'll see the belt tension-er looking like it's pointing to the northeast of the little diagram.. the easiest way to relieve the pressure is get a crowbar, pull up on the tension-er until it relieves the pressure. I'm actually putting a new belt on my 91' 3.1 Corsica
If it is a drive belt and not a serpentine belt is has no tensioner. You manually adjust the tension by normally adjusting tension by moving the alternator. Loosen to bolts holding the alternator in place and then adjust the tension. Tighten the bolts when the tension is right. If it is serpentine belt if you follow the belt around the the engine you will see the tensioner.
To loosen the tension on a serpentine belt on a 2005 Grand Caravan 3.8L, turn the nut of the belt tension pulley to loosen it. Adjust the belt, then tighten the tension pulley by turning the nut in the opposite direction.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
There should be a diagram on the underside of the hood.