0
i did my brakes most of the time it will only need an hour of my time to do both front brakes.....
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How many hours will it take to unclog the catalytic converter on my 1996 jeep grand cherokee limited 5.2?
You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.
How much labor to replace heater core on Volvo 940?
About 10.5 hours if good mechanic. Nasty job as it is behind the fire wall. You have to take the dash and the front console out just to get at it.
How many labor hours for a flywheel on a 96 Chevy truck?
It will take and experience mechanic six hours to replace your 1996 Chevy truck flywheel. A novice mechanic will take several more hours.
How many mechanic hours are estimated for a pro mechanic to replace an alternator in a 1998 Honda Civic?
parts and labor it should run you about $300 and change. Replace the drvive belts too.
How do you replace the alternator on a Fiat Punto 90 ELX Cabrio?
get a mechanic mate. its in a difficult position under the engine and the front exhaust has to come off. �100 for a new alternator and 3 hours labour.
How many mechanic hours would it take to replace an ignition coil in a 05 volkswagen jetta?
2
How much should it cost to replace brakes on an Acura MDX?
About 1 hours labor, plus parts
How do you repair the brakes in a 1997 Chrysler Cirrus LXi with abs disk brakes?
the best thing to do is to get a manual. Front disc brakes are really easy to change out only maybe two bolts hold the rotor on to the disk and the pads are held on with clips. The best thing to do is get a manual it will have a troubleshooting section in it too. Follow the insturctuions to the T and it will be just like having a mechanic do it. The abs system must be hooked up to a computer and bled by a shop. you can replace the brakes without bleeding by carefully pushing the calipers back with a caliper compressor. if you have to bleed it it costs about $45 in qa shop for and hours labor.
How many hours to change front wheel bearing on 2001 venture van?
I you are a good mechanic, and have all the right tools, about 3 hours.
How many mechanic hours would it take to replace a water pump on a 1994 Plymouth duster?
two to four hours depending on your machanical ability
How many hours does it take to remove and replace a 2006 Honda civic motor?
According to our fleet mechanic. The time in the book says 18 hours.
How long to replace a Nissan skyline clutch?
I can do it in about 2.5 hours. Any competent mechanic should also do it in under 4 hours. But they will charge for 6-8 hours FYI
