You will need to go to your local parts store and make sure to get the correct oil pressure switch or if you have a local Cummins dealer you can ask them. I got mine there for a third of the lowest price. It is located on the drivers side of the motor and is be hind some electrical connections so it is hard to see. It is closer to the front of the motor. It takes either a 1 1/4 inch or 1 1/6 inch socket. Make sure and get it tight as to not have a leak but not over tighten and strip. Also MAKE SURE AND GET THE RIGHT SWITCH. If you get the wrong switch or the some of the single lines you may have to reprogram your ECM. If you are not experienced DONT TRY THIS. H&N Auto, Boise Idaho
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
There is a fuse, relay and switch on the low pressure side that will inhib compressor from turning on if there is not enough pressure.
is the ecm on a dodge 2001, 2500 diesel hard to replace??
Dodge Durango is not equipped with a fuel pressure switch
* P0521 Engine Oil Pressure Sensor/Switch Circuit Range/Performance
how do I replace block heater on 1995 dodge ram 2500
Dodge does not use inertia/ reset switches.
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
The Plug that is hooked to the head light switch is melting, Get a new switch at a parts store, it will come with a new plug, it will be necessary to splice (solder) the plug. If you do not replace the plug and switch it will start a fire in the dash.
it depends on the size of the diesel engine going in so yes and no
Mainline pressure will be 55psi on a stock transmission
Power steering pressure switch.Power steering pressure switch.