Did you delete the code? After you fix the problem you have to connect the computer back and delete the code. If you dont the code will still pop up
keep it from changing on time
for example like a cow dies and you keep getting and getting more cows
pay attention in you fu****g class
I HAVE BEEN BILLING THE j0696 WITH THE NDC CODE 6467998301 BUT KEEP GETTING DENIALS. IS THERE ANOTHER CODE?
I HAVE BEEN BILLING THE j0696 WITH THE NDC CODE 6467998301 BUT KEEP GETTING DENIALS. IS THERE ANOTHER CODE?
Follow the code of the four F's
Assuming this is a PowerGlide or Turbo-350 automatic transmission vacuum modulator, to minimize fluid loss jack up the rear of the truck and support with suitable jack stands, place a drip pan under the modulator, pull off the vacuum line from the modulator, remove the small bolt and clamp holding the modulator in place, gently twist and pull the modulator out taking care not to lose the small actuator pin inside. Keep the dirt from entering the opening. Install the new modulator with a new o-ring.
You need to get the battery in the game cartridge replaced. Most gamestops will do it for you.
Make sure you replaced the sensor with the two wire connector. Make sure the connector to the sensor is corrosion free. Replace it if it is
Perhaps it's getting used too roughly or it has gotten torn or dust has gotten into it.
Keep getting e code when first turn on will not work u
no, just keep going on walks and getting presents. : )