Check your switch with a voltmeter for continuity in all positions. Get the electrical schematic to your vehicle to help troubleshoot. The average fan is receiving direct voltage on "High" setting but is slightly cut down in increments on other settings by a resistor or rheostat network. Hence lower voltage produces lower speed. You more than likely have a bad control switch.
Failed blower motor, resistor or switch.
Because it needs a new blower motor resistor.
when a blower motor only works on high, it is usually due to faulty resistor board. Should be located in the duct near the blower. the purpose of this is so the air blown by the blower keeps the resistors cool.
The blower motor speed resistor is burned out.
Blower fan inoperative or only works on high speed.
my 2005 dodge caravan front blower worked in the pm for the last time the back one still works. found the fuse box under the hood is there another inside the van?
well that's what mine is doing im trying to fix the blower motor resister pack if that works ill let you know cause we have fixed everything else that's all that's left i think
replace the blower motor switch
You need to replace blower motor resistor.
Probably your blower motor speed resister is burned out.
If the one speed it works on is high speed, it is the blower motor speed resisitor that is bad.
The blower motor works on only one speed. The blower motor resitor pack is defective and needs to be replaced. It is located on the blower housing in the engine compartment just below the blower motor.