You may have a leak. If you add water so that it's up to the middle of your skimmers, and within 12 hours the water level has gone down more than 1/4 inch or so - you probably have a leak. If it takes several days for the level to go down, it's more likely to be evaporation.
water always flows from high level to low level. Also in drainage the principle is high level to low level....
Improperly sanitized water or excessive rainfall can cause a low total alkalinity level in your pool. Low total alkalinity can cause pool staining, itchy and burning eyes and skin, and corrosion of metal parts in the pool.
Improperly sanitized water or excessive rainfall can cause a low total alkalinity level in your pool. Low total alkalinity can cause pool staining, itchy and burning eyes and skin, and corrosion of metal parts in the pool.
That all depends on the size of the surface of the pool the amount of people going in and out of the pool etc. To see if a pool is leaking take a bucket of water out of the pool, mark the water level of the pool and the water level in the bucket. Then leave the pool and bucket alone for a day or two. if the water level in the pool has gone down more then the water level in the bucket then there is a leak or water is being removed in some way. If the levels are the same then the water lost is a result evaporation.
Could be the water level of the pool is too low. Top up with the hose into the skimmer basket.
Low Calcium Hardness in pool water means that there is low calcium in the water and is considered "soft" and soft water tends to be corrosive. It will etch away and your plaster and any metal object the pool water touches.
Yes, there is a built in method for lowering the water in an in-ground pool, which high end pool companies use on a regular basis. It is used in combination with the system that also adds water when the level drops too low. About one foot below the surface of the water there is an opening that leads to a chamber built into the side of the pool. When the water is too low a valve (similar to the one in a toilet) opens up and allows water to flow in from your home plumbing. When the level is too high the water flows into a pipe that routes the water to the gravel under the bottom of the pool where it is absorbed by the ground. Works really well!!
If you are getting a low reading of chlorine in your above ground pool, you should add the appropriate amount of chlorine to get it back to the correct level. This is important to keep your pool running at maximum abilities.
The water in the pool is too low,
Count your blessings, free water. If you have a salt water pool you are better of hanging on to it because if you dump you weaken the salt in the pool. If you feel that you need to have the skimmer working properly which is important in keeping pools clean you could get a floating pool skimmer which will work whether the water is high or low. Regardless of what you do evaporation will soon bring the water level down again.
Regardless of the position of any tiles on the pool wall The water level should be about 3 or 4 inches / 75-100mm above the top of the skimmer vein before the skimmer basket or at such a level that it does not suck air through the skimmer. of you have a suction side floating pool skimmer you can let it get as high as you like and as long as it is sealed properly as low as you like.
Water always flow from height to bottom mean high potential level to low potential level same happens in electrical circuit.