answersLogoWhite

0


Best Answer

My wiper failed on my 2001 Venture. I took it apart. There were two problems. 1) the shaft for the wiper was stiff/almost seized- apparently that is commong and can be corrected by drilling a little hole into the housing from under the plastic outside cover to be able to add oil.

2) the nylon gear was stripped probably from being too still or frozen with ice. The motor is strong enough to strip the nylon gear. The Venture rear motors seem to be a common problem and expensive$250 rebuilt. I plan to replace mine with a similar one from a 1994 chev lumina and to add a 10 amp circuit breaker to the power from the ignition to avoid stripping the gear again with ice. The 1994 has three inputs- constant power from ignition, power signal from the switch and ground in the center pin. I am hoping to be able you use your information to power the reliable old 1994 wiper motor that seems to be a more dependable design with no seizing or stripping problems- probably cheaper too.

488ray

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Rear Wiper doesn't work; 2000 Chevy Venture Replaced the motor but that didn't fix it With ignition on you have 14vdc on white wire 2 With rear wiper switch on you have 14vdc on gry wire 1?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

I have a 1997 Ford Aspire that I replaced the ignition switch. I now dont have any fire to the ignition. Is there a problem with the ignition module or the ECM?

are all the connection plug in on the switch and did you have fire before replaceing switch


How do you remove the ignition switch of a 97 Suburban?

you can take it to be replaced it has a recall on them


How do you change the ignition switch on a 2002 Hyundia Accent?

To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.


Why won't my ignition switch turn on or off in a1991 Chrysler New Yorker?

It sounds like your ignition switch will need replaced. The one that is inside your steering column.


Why does your engine still run when you take the key out of the ignition?

check the ignition switch , it might be bad and may need to be replaced.


Integra 96 why it crank but won't start?

the wires from the ignition switch need to be replaced.


92 Chevy 2500 you have replaced the starter when you turn the key the starter wont engage?

This could be a bad ignition switch, ignition relay, or ignition fuse.


Ignition switch will not turn on 1998 Chrysler concord?

tumbler has slipped. hit key with mallet . but ignition keylock will soon have to be replaced


How do i start my astro van when the key will not turn in the ignition?

get a new key or break ignition with flathead screwdriver or try wiggling old ket around Appended Aug. 7th, 2010: Possible pass-lock failure. this is a switch that is part of the ignition switch, and must be replaced with the whole ignition switch.


How do you depress the holding pins on the ignition switch on a 1995 Ford Escort?

you cant. it has to be replaced as a unit


Why is it when I replaced my ignition switch in my Cadillac Catera my car just cranks and cranks but will not start?

its not your ignition its your crankshaft sensor that's the same problem i had.


You replaced the complete ignition switch the car starts now but the shift lever wont budge how do you fix that Its a 91 190?

you must check the brake pedal release switch it will have probably failed at the same time as the ignition switch was replace by coincidence or you bumped the wire off replacing the ignition switch