Turn the key to the run position and depress the accelerator 3 times to the floor within 5 seconds. The light should blink and then go out.
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...
This is how to reset the "CHANGE OIL" light for a 96 Impala SS: 1. Turn the key to the "RUN" position with the engine OFF. 2. Push and release the gas pedal three times within five seconds. 3. Wait for the "CHANGE OIL" light to flash two times as a confirmation that the system has been successfully rest. If the "CHANGE OIL" light comes on and stays lit for five seconds, the system has NOT been reset. Therefore, you must repeat steps 1 & 2.
See {How to Reset the Engine Oil Life System} on page 5-21 of your "Owner's Manual", under Section 5: Service and Appearance Care.....
Listed in detail in your owner's manual. Don't have one then you need to get one.
HOW DO YOU RESET OIL LIGHT ON CUD CADET
How do you reset the oil light on gmc c7500
Turn on the ignition but do not start the engine. Depress the accelerator to the floor 3 times within 5 seconds. The oil light should blink and then go out.jd
It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.
Reset the change oil light on Mazda 3
== == how do you reset the oil light on a1992 corvette