0
The Cruise control in your 200sx failed to disengage after changing the idle air control valve and had problems with the EGR system please help?
Wiki User
∙ 12y ago
make sure the vacuum line is connected to the ball looking part. It's like a 4" round item I believe on the drivers side close to the firewall. Good luck
My EGR failed and set a code. It turned out to be the thing in the same location that looks like a little space ship. It had a hose coming off of the bottom of it that was rotted through. Also, where this hose connected to the little space ship is a small pin hole. It was plugged with carbon so I took a small piece of wire and unplugged it. Cost less than $2 for a piece of hose and no more EGR problem.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Could a faulty brake light switch cause the cruise control to disengage while driving and also cause the engine to surge and cause the truck to act as if it has transmission problems?
yes.tcc will not work corect or cruise control
Does brake light come on when cruise control disengaged?
no it does not.unless you disengage with the brakes,not the control button
Cruise control problems on 2004 dodge 2500?
cruise would work but if i push to accelerate it would disengage an truck only after restarting would it work again. Now it does'nt work at all. Any suggestions?
Where is th location of the 1999 Tachoe break switch?
Down on the brake pedal. It will also disengage the cruise control.
Why does cruise control disingauge going up hill?
Most cruise controls will disengage if the gas pedal has to go too far or if the speed drops too much.
Why does the cruise control on your 1996 two wheel drive Tahoe disengage on a slightly bumpy road?
bad connection at set button on collumn
Why my cruise control dont work on my 1998 cadillac deville?
90 Percent of cruise control problems caused by defective cruise control release switch located near top of break pedal.
How do you deactive deactivate auto cruise?
tap the brake pedal there is also a cruise control wand immediately behind the steering wheel at approximately the 10'o'clock position. You can control the cruise control with this stalk. Pushing it forward while you are at a steady speed will lock the speed in. Pushing the stalk forward will disengage CC. Pushing it down will slowly reduce the speed. Pulling it back will slowly raise the speed. But touching the brake should always completely disengage the system.
Why did my cruise control quit working after I change out my BOO switch on 98 mustung?
The most probable cause for your malfunctioning cruise control is a blown fuse. The fuse might have blown while you were changing your switch. The cruise control fuse can be found in the fuse box.
Where is the clutch inhibitor switch located?
Its at the top of the clutch pedal there is a cruise control switch disengage switch at the bottom and the one above that is the clutch inhibitor switch.
What could cause that the cruise control switch doesn't work in your 02 impala?
most cruise control problems are caused by a leaking vaccum canister that controls the throttle on the cruise, your switch is probably fine.
What is cruise control an example of?
Cruise control is an accessory.
