The wiring harness is a bunch of wires together running from the ecu and tcu to all of the components under the hood. If you need to remove the harness, I warn you, its a pain in the butt. If you are going to remove it, you can email me and I will be glad to go through step by step instructions.
try www.installdr.com
can you used a 2.0 liter complete witing harness for a 2.4 mitsubishi eclipse spyder engine
go to wal mart and get the wire harness it will tell you what goes where.
You need to remove the dash panel. It will allow you to get access to many connectors and it will be easier to remove the harness.
8750A143
Not without serious mods. For example coumputer, motor mounts, and wiring harness.
Begin by removing the middle of your 1992 Mitsubishi Montero steering will. Remove the wiring harness. Remove the steering wheel retaining bolts.
Definitely not an easy task. You would have to remove the whole dash, the ECU/TCU is located in the center bottom of the dash. Once the dash is removed the wiring harness is under the rubber material, then you would have to feed it through the firewall and on the other side (engine bay) disconnect the harness from the various engine components.
You can find a wiring diagram for your 1988 Mitsubishi Gallant at most Mitsubishi dealerships. Mitsubishi service manuals will have the wiring diagram and can be found at most local libraries.
Wilson the alternator belt. With the tensioner pulley. Remove the wiring harness from the alternator. Remove the four alternator retaining bolts.
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.