0
What do you call a push button switch that you push on when power supply shut down you have to push it on again?
Wiki User
∙ 15y ago
That would be a breaker, as in circuit breaker. Just like the ones on your house.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Which switch supply power to a computer?
normally the power button :)
How do you install push button start?
find the ignition wireing diagram and put a switch on the supply power and button on the starter
What is a detent switch?
It's a latching push button switch. To operate this type of switch, you press the button, which then latches into place. To switch off, you press the button again, which returns to its home position. Just like the power switch on your TV or HI FI.
Why would the system power on when the power switch in the back is flipped but does not boot until the front power button is pushed?
The switch on the back is the switch for the power supply only. The computer boots from the main power switch on the front. This particular method of switching was introduced with the ATX power supplies.
Have a e mach t2460 need to know where power sw?
E machines do not have a power switch located by the power supply box. They only have the power button in front of tower.
Which device gives the power supply in computer?
SMPS(switch mode power supply)
Monitor power button switch working but power is not out put in the monitor?
if it says power button locked hold "<" button and power button till the message goes.(at least a min)
Is fuel shut off switch supposed to be up or down on a ford escort wagon to be able to start your car again?
The button is supposed to be DOWN ( if the button has popped up then the switch is " tripped " and no power is going to the electric fuel pump )
When switch is off of power supply output shown on the multimeter is negative voltage from power supply?
Yes.
What does SMPS stand for?
SMPS stands for switched mode power supply
What hardware system do you first assume is at fault?
The obvious answer would be the Power Supply Unit (PSU). This starts the computer and without it nothing can work. On the other hand if you have a faulty mother board or RAM, the computer would switch on but nothing would be shown on the screen. The PSU is found on the highest part of the tower. Also check the the switch (if it has) is switched on, and that the power supply cable (the 3 pin one) works.
Full form of smps?
it is used to supply power to motherboard and other peripherals
