answersLogoWhite

0


Best Answer

here's a few more pennies... The glue preferred by pool pros for this application is Mr. Sticky's Underwater Glue. It is sticky underwater, does not become brittle, easy to work with. you can find it at mrstickys.com

Well here is my 2 cents worth, I am not in the pool repair business but my pool, when it was repaired (vinyl) , The repair crew used the de-watering lines that were used to install my pool, If you have them on yours is a guess, as I do not know how high your water table is, but if they are there they should have been cut off below grade and capped in case they are needed for future problems like this, The pool company thet installed your pool, if known, should know where they are located, I hope this is of some help.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What do you use to patch a hairline crack on the bottom of a cement pool that is still weeping water if you paint over it with super epoxy two-part paint?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes cement to peel away?

Moisture under hairline cracks.


What is the sand and cement ratio for grout bottom in pools?

7 Parts sand to 1 Part portland cement


How does a small cement silo work?

A small cement silo works by storing dry cement powder and releasing it into a mixer or conveyor system through a controlled discharge mechanism. The silo typically has an aeration system to prevent clogging and ensure a consistent flow of cement. The cement is loaded from the top and can be unloaded from the bottom through a screw conveyor or air slides.


What is correct set the bag of cement down over there or sit the bag of cement down over there?

"Set the bag of cement down over there" is the correct usage. ---- To Set = to place something deliberately to adjust something to arrange something To Sit = to put your bottom in a chair to rest


What is the use of bottom plug in ship?

Ships bottom plugs are provided for an easy access in dry docks to enter ships double bottom tanks. These plugs are fixed and sealed with cement from outside before leaving the dry docks.


Where can you purchase vermiculite to repair your pool and how is it applied?

Vermiculite is available at Garden Centers. They use it in for plants and trees. Also, Home Depot and Lowes. Vinyl liner pools are built on the cheap. Rather than pour an 8" concrete bottom, or even shoot on gunite, by first building a cage of wire and Rebar, they mix cement with vermiculite and trowel on a 4" bottom. Without the vermiculite, the bottom couldn't withstand the hydrostatic pressure underground, and would lift up like a volcanic eruption. The vermiculite permits water to come up thru the bottom because the cement is now porous. Installation is accomplished by mixing the vermiculite into the cement prior to troweling it onto the entire bottom, which includes the vertical surface up to the bottom of the 3 1/2' wall (steel, fiberglass, wood, or whatever). Experience mixing and troweling cement is advised. Good luck


Is it easier to run on grass or cement?

cement cement it is easier to run on cement cement


Why is there yellow algae forming in the bottom of your cement pool?

Sounds like mustard algae. Usually happens after a lot of rain or warm weather.


What is the difference between concrete mortar and cement paste?

Cement paste is formed when cement is mixed with water. However, cement mortar is formed when cement is mixed with fine aggregate (sand) and water.The strength of cement mortar is more when compared to cement paste.Shrinkage will be less in cement mortar and high in cement paste.


How do you you pump a balanced cement plug?

Balanced cement plug is pumped through drill string or open-ended tubing. 'Balanced Cement Plug' means that the top of cement outside the drillstring/ tubing will be the same height as the top of cement inside the drillstring at the end of pumping. The drillstring/ tubing is then slowly pulled from the wet cement, allowing the cement inside the string to fill the centre of the plug. There are lots of refinements in this method with open hole cement retainers or high viscosity 'cushions' often placed below cement. In vertical hole, most balanced plugs are successful. In extended reach wells, failure rates can be high with cement slumping and mixing with synthetic based muds. A typical checklist to improve cement plug success in extended reach wells would have: 1. Always use a tailpipe. This reduces the disruption to the plug caused by removal of the drillstring. 2. Clean up the hole thoroughly before pumping cement. Cement is an excellent hole cleaner. Many 'flash set' events reported are really packoffs caused by cement picking up a cuttings dune. 3. Put a diverter tool with BIG holes on the bottom of the tailpipe. This directs fluids up the hole during cementing 4. Use a scavenger spacer in front of the cement job to convert the formation from oil wet to water wet. 5. Slow down pumping to 1 BPM while displacing cement into open hole. This reduces mixing of cement and mud. 6. Put a cushion below the cement plug. A cement retainer is best. If a viscous cushion is spotted, weight the cushion to 1 ppg below the cement weight. 7. Gravity is NOT on your side. Cement can stay inside the tail pipe as you pull it from the plug. Pump the volume of cement inside the tailpipe as you pull the tailpipe from the plug. 8. Circulate clean the long way with the bottom of the tailpipe at the planned cement plug top.


What the cement equation?

cement = cement hope this is helpfull


What is the difference between cement and mortar and concrete?

Cement paste is formed when cement is mixed with water. However, cement mortar is formed when cement is mixed with fine aggregate (sand) and water.The strength of cement mortar is more when compared to cement paste.Shrinkage will be less in cement mortar and high in cement paste.