It means the same as on any other car on the planet. Nothing wrong with your engine (probably) the light is all about your exhaust emissions system. Amazingly enough, the most common reason for that light coming on is that you did not tighten your gas cap enough clicks when you last filled up. Sometimes when you next fill up and tighten the cap properly it will clear the light because the tank is pressurized again. SOmetimes the light needs to be reset. AutoZone will "read" you computer and confirm what the light means if you still have trouble with it. Unless your car is driven at 20mph everywhere, your catalytic convertor is probably ok Phil
common problem with 1998 mystique check engine light on
The check engine light is the light shaped like an engine, or the light that states Check Engine (Soon). If this light comes on, it is time to see what the issue is with the engine.
If the check engine light is blinking , an engine cylinder misfire has been detected
High idle, misfire, check engine light,High idle, misfire, check engine light,
AnswerTo the right of the rear window defroster button, behind a plastic cover. Just pop it off with a flat head screw driver.On my 1998 Cabrio, I found it to the right of the ash tray. Remove ash tray then slide the cover to the immediate right of the ash tray to the left to reveal the OBDII connector.
An engine misfire has been detected
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
A quick way to reset the check engine light would be to disconnect the battery for a short while
There is no dedicated fuse for the light.
The antifreeze is low in the reservoir.
You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.