0
what size engine 2.2
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is crank sensor located on 99 Cherokee xj?
The crank sensor is on the top driver side of the bell housing.
Where is the crank shaft position sensor located on a 99 Pontiac Gran Am?
IT SHOULD BE LOCATED UNDER THE MANIFOLD BOLTED TO THE BLOCK
Where is crank sensor for 99 hynda elantra?
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
Where is the crank position sensor located on a 99 Isuzu trooper?
If its a 3.0 td model the crank sensor is situated on the o/s in the engine casing , its accesible from underneath with a long extension and a 10mm socket
Where is the crank sensor located on a 1999 Chevy Suburban?
Right above the starter, but you'll have to first drop the starter to get access to the CPSensor. my son in law has a 99 suburban 5.7 and the crank sensor is located on the passenger side of engine at the front by the timing chain cover.
99 Nissan maxima eccs relay not powering crank sensor circuit?
Where is the ECCS RELAY LOCATED ON 1999 NISSAN MAXIMAType your answer here...
Does a 99 Chevy have a cam sensor and a crank sensor or just one?
It has both, The crank sensor is on the timing cover passenger side behind the balancer. The cam sensor is the distributor, Inside of it.
Where is the crankshaft sensor on your 99 buick regal?
Behind the crank pulley
How do you replace the thermostat located on a 1994 Chevy Cavalier?
where do i find the thermostat for 99 cavalier
Where is crank sensor 99 jeep 4.7?
You have to remove the starter and the sensor is behind there in the rear of the engine block.
Where is a crank sensor on a 99 Chevy Astro van?
Do you have a 4.3L with a distributor? If so, the crank sensor is in the distributor and may also be called an HEI pickup or Hall switch.
Where is the crank shaft position sensor on a 2002 cadillac deville?
All Northstars have 2 crank sensors, there are located just to the side of the oil filter adapter & behind the front motor mount. I strongly you forget about figuring out which one is sensor A & which is sensor B. Replace both! 93-99 are the same part number for both sensors & are interchangeable. 2000+ have 2 different part numbers for each sensor & are not interchangeable with the 93-99 sensor.
