answersLogoWhite

0


Best Answer

its part of your distributor cap. hope this might help.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the negative coil wire and where is the coil?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What wire on your ignition coil on your 99 Cherokee XJ is negative?

The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.


How do you hook a Pro comp distributor to motor With a exturnal coil?

red (+) wire to possitive side of coil- Black (-) wire to negative side of coil. thats it.


What color is the negative coil wire on a 91 mustang?

green.


Where do you hook up the tach wire on the coil of your 92 thunderbid 302 engein?

Hook it to the negative side of the coil.


What coil wire goes to distributor?

assuming it is a older car with points the distributor goes to the negative side of the coil


Where you need to connect the green wire from a tachometer?

the green is the signal wire and it goes to the negative side of the ignition coil


How do you hook up a hei distributor with external coil to a tachometer?

The green wire from the tach goes to the negative side of the coil.


How do you know which wire is positive and which is negative on the electronic ignition coil for a 90 Prelude?

thganr


Where is the tach signal wire on a 1998 Crown Victoria?

If your car has a distributor it is the negative on the coil.


Which wire is positive and which wire is negative on 1998 4 liter grande Cherokee ignition coil?

The dark green/orange wire is the power feed.


How you wire a RPM gauge in to a vw?

follow the instructions, if you have no instructions then ussualy one wire to negative side of coil and the other wire goes to ground.


How do you connect a tachometer to a 2001 S-10 with a 2.2L?

The green wire is supposed to go to the negative wire of the coil , that is usually a white wire, but make sure that the tachometer documents tell you to use the negative wire it is usually the white wire. If you have a test light hook the cramp to the negative of the battery and check the two wires if the light glows that is the positive, connect the green wire to the other wire it will be the negative. There are some that say to use the positive, ""PLEASE READ THE INSTRUCTION VERY CAREFULLY"" Or you could short out the coil and the igition module.